Atlas IED CP700RRK Installation Guide

CP700RRK
CP700 REAR RACK RAIL KIT

INSTALLATION INSTRUCTIONS

Step 1:

Install the amplifier into the cabinet and then
snap the side rails over the back of the amplifier.

Note: If the amplifier is being installed in an 181⁄2"
Deep Cabinet. The side rails will have to be
shortened by removing the perforated sections.

A

Step 2:

Slide the lacing bar through the slots at the back of
the side rail.

B

Step 3:

Position the lacing bar, use the
lacing bar and the 1⁄2" screws for the rear rails.

1

⁄4" screws for the

DETAIL A

SCALE 1:3

DETAIL B

SCALE 1:5

Specifications are subject to change without notice

AtlasSound.com

©2006 ATLAS SOUND LP Printed in U.S.A. ATS002454 RevA 08/06 490759

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: [phone] • FAX: [phone]