Atlantis Land NetCamera 800NV A02-OIPCAM1, NetCamera 500 Quick Start Manual

Package contents

System requirements

The product

Before proceedwith the productusage please checkthe package contents:

-IP Camera

-Power supply

-Mounting bracket

-Quick Start Guide

-CD-ROM

Configuration

Turn onyour PC andput the providedCD-Rom in yourCD-Rom reader.A welcome
page willappear. Select the purchasedNetCamera and clickon “Intelligent IP
Installer” link,then follow thenext steps.

1 .Click ” ” toproceed with theinstallation procedureYes

-1- -2 -

-4--3-

2. Selectdesired language anclick ”Next”

3. Click to goto the nextstep"Next”

4 .Click to goto the nextstep"Next” 5.Click togotothenextstep"Next”

6 .Click to goto the nextstep"Next” 7 .Click” ” then to complete

the installationprocedure.

Install “Finish”

Before proceedwith product installation,please make sureyour system isin
compliance withthe following requirements:

-Windows 98,ME, 2000, 2003,XP or Vista

-Internet Explorer6.0 or later

QUICK START GUIDE

A02-IPCAM5_GE01

www.atlantis-land.com

NetCamera 500

A02-IPCAM5

Focus

Bracket

Microphone

Audio output

Bracket mountinghole

Reset

Network

Power

-6--5-

--7

“Intelligent IP Installer” software

Launch thesoftware just installed,then click on button.“search” 1. Duringthe first access,the web browserwill need toinstall the ActiveX viewing

software.

2. Clickon to proceed.”Install ActiveXControl”

3. Click to installthe ActiveX software.“Install”

4. Nowyou can useyour NetCamera throughthe web browser.

The “IntelligentIP Installer” software,will automatically recognizethe cameras

connected tothe network. Click to openthe WEB configurationpage.

Use thefollowing username andpassword to proceedwith the productconfiguration.

Username: admin

Password: admin

“Link toIE”

Viewing the images

NOTE: TheNetCamera is configuredto get adynamic IP addressfrom a DHCPserver

in thenetwork. If DHCPservice is notavailable, the NetCamerawill use anIP address

in therange from 192.168.1.2to 192.168.1.254. Inthis case, put192.168.1.1 IP

address inyour PC networkcard configuration inorder to startthe product configuration.

CE/EMC restriction of liability

CE Mark Warning

The product described in this handbook was designed, produced and approved according to
the EMC-regulations and is certified to be within EMC limitations.
If the product is used in an uncertified PC, the manufacturer undertakes no warranty in
respect to the EMC limits. The described product in this handbook was constructed,
produced and certified so that the measured values are within EMC limitations. In practice
and under special circumstances, it may be possible, that the product may be outside of the
given limits if it is used in a PC that is not produced under EMC certification. It is also
possible in certain cases and under special circumstances, which the given EMC peak values
will become out of tolerance. In these cases, the user himself is responsible for compliance
with the EMC limits.

This is a Class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

Use of audio or video equipment for recording the image or voice of aperson without their knowledge
and consent is prohibited in certain states orjurisdictions. Nothing herein represents a warranty or
representation that the Atlantis product provided herein is suitable for the end-user's intended use
under the applicable laws of his or her state. Atlantis Land SpA disclaims any liability whats oever for
any end-user use of the Atlantis product, which fails to comply with applicable state, local, or federal
laws.

ATTENTION

Important information for the correct recycle/treatment procedures of
this equipment

collected

separately

The crossed-out wheeled bin symbol printed on the unit label or unit packaging indicates that
this equipment must not be disposed of as unsorted municipal waste but it should be

. The waste of electric and electronic equipment must be treated separately, in
order to ensure that hazardous materials contained inside the equipment are not
buried thereby providing potential future problems for the environment and human
health. Moreover, it will be possible to reuse and recycle some parts of the waste of
electric and electronic equipment, contributing to reduce the quantities of waste
to be disposed of and the depletion of natural resources.
As user of this equipment, you are responsible to return this waste of
electronic equipment to an authorised collection facility set up by your
Municipality. More detailed information on your nearest collection centre
can be obtained from your Municipality or from other competent local
entities.
If you are replacing the old equipment with a new equivalent product, the
distributor must take-back the old equipment free of charge on a one-to
one basis as long as the equipment is of equivalent type and fulfilled the
same functions as the supplied equipment.
Your rôle in participating to the separate collection of waste of electric and
electronic equipment is essential to ensure that environmental protection
and human health objectives connected to a responsible treatment and
recycling activities are achieved.

PS.: The above mentioned information are reported herewith in compliance with Directive
2002/96/CE, which requires a separate collection system and specific treatment and
disposal procedures for the waste of electric and electronic equipments (WEEE). For
further and more detailed information, we invite you to visit our website at www.atlantisland.
com