Atlantis Land I-FLY A02-WR-54G/G2, I-FLY A02-WR-54G, I-FLY A02-WR-54G2 Quick Start Manual

I-Fly Wireless Broadband Router

with 4 Fast Ethernet ports + 1 Wan port

Quick Start Guide

A02-WR-54G/G2 (November 2003)V1.00

I-Fly Wireless Broadband Router

2

For more detailed instructions on configuring and using the I-

Storm Lan Router ADSL, please refer to the online manual.

1.1 Package contents

Make sure that you have the following items:

• I-Fly Wireless Broadband Router

• Network cable (CAT 5)

• Power Adapter AC-DC (5V, 2A)

• CD-ROM (with manual, software and driver)

• This Quick Start Guide

If any of the above items are missing, please contact your reseller.

1.2 Cabling

Connect to RJ45 ports by an Ethernet cable your PCs or Switch.
Finally connect the Adapter to power inlet. Now the I-Fly Router
will enter a self-test phase for about ten seconds. After this phase

the STATUS led will be flashed to indicate that router is in normal
operation. Now you should see the LAN (WLAN/WAN) is solid
or blinking. A solid light (POWER Led) indicates a proper

connection to the power supply.

I-Fly Wireless Broadband Router

3

1.3 The Front Panel LEDs

LED MEANING

POWER

ON=Indicates proper connection to power supply.
OFF= The unit is not receiving power

STATUS BLINKING=Indicates that the device is ready.

WAN

ON= Indicates connection to the WAN port

BLINKING= Data transmission.

WLAN

ON= Link is established
BLINKING= Packet tra nsmit or receive activity
OFF= No Link activity

LAN

ON= Indicates connection is established.
BLINKING= Data transmissions
OFF= No LAN connections

I-Fly Wireless Broadband Router

4

1.4 The Rear Ports

PORT MEANING

LAN
(4 *RJ-45)

Auto MDI/MDIX LAN ports automatically sense the
cable type when connecting to
Ethernet-enabled computers.

WAN

The Auto MDI/MDIX WAN port is the connection for
the Ethernet cable to the Cable or DSL modem

RESET

After the device has turned on, press it (10s) to reset the
device or restore to factory default settings.

POWER (Jack)

Receptor for the Power Adapter

1.5 Default Settings

Before you configure this I-Fly Wireless Broadband Router, you
need to know the following default settings.

Leaving these settings, configuring the PCs such as DHCP client
(follow the instructions below) . You can configure the I-Fly

Router quickly. For a more detailed configuration refer to manual
on Installation CD.