Atlantis Land A02-IPCAM5 User Manual

NetCamera 500

A02-IPCAM5

System requirements

Before proceed with product installation, pleasemakesure yoursystemisin
compliance with the following requirements:

-Windows 98, ME, 2000, 2003, XP or Vista

-Internet Explorer 6.0 or later

Bracket mounting hole

Power

Reset

QUICK START GUIDE

A02-IPCAM5_GE01

Package contents

Before proceed withthe productusage pleasecheckthe packagecontents:

-IP Camera

-Power supply

-Mounting bracket

-Quick Start Guide

-CD-ROM

The product

Focus

Microphone

Bracket

1 .Click ” ” to proceed with the installation procedureYes

2. Select desired language an click ”Next”

-1- -2 -

Network

Audio output

Configuration

Turn on your PC and put the provided CD-Rom in your CD-Rom reader.A welcome
page will appear. Select the purchased NetCamera and click on “Intelligent IP
Installer” link, then follow the next steps.

4 .Click to go to the next step"Next” 5.Click togotothenextstep"Next”

www.atlantis-land.com

3. Click to go to the next step"Next”

6 .Click to go to the next step"Next” 7 .Click ” ” then to complete

-4--3-

Install “Finish”

the installation procedure.

“Intelligent IP Installer” software

Viewing the images

Launch the softwarejustinstalled,thenclickon button.“search” 1. Duringthefirst access,thewebbrowserwillneedtoinstalltheActiveX viewing

NOTE: The NetCamera is configured to get a dynamic IP address from a DHCP server

in thenetwork.IfDHCPservice is not available, the NetCamera will use an IP address

in therangefrom192.168.1.2to192.168.1.254.Inthiscase,put192.168.1.1IP

address in yourPCnetworkcardconfigurationinordertostartthe productconfiguration.

The “IntelligentIPInstaller” software, will automatically recognize the cameras

connected to the network.Click to open theWEB configurationpage.

Use the followingusernameandpasswordtoproceedwiththeproductconfiguration.

Username: admin

Password: admin

ATTENTION

Use of audio or video equipment for recording the image or voice of aperson without their knowledge
and consent is prohibited in certain states orjurisdictions. Nothing herein represents a warranty or
representation that the Atlantis product provided herein is suitable for the end-user's intended use
under the applicable laws of his or her state. Atlantis Land SpA disclaims any liability whats oever for
any end-user use of the Atlantis product, which fails to comply with applicable state, local, or federal
laws.

CE/EMC restriction of liability

The product described in this handbook was designed, produced and approved according to
the EMC-regulations and is certified to be within EMC limitations.
If the product is used in an uncertified PC, the manufacturer undertakes no warranty in
respect to the EMC limits. The described product in this handbook was constructed,
produced and certified so that the measured values are within EMC limitations. In practice
and under special circumstances, it may be possible, that the product may be outside of the
given limits if it is used in a PC that is not produced under EMC certification. It is also
possible in certain cases and under special circumstances, which the given EMC peak values
will become out of tolerance. In these cases, the user himself is responsible for compliance
with the EMC limits.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

“Link toIE”

software.

2. Clickon to proceed.”Install ActiveX Control”

3. Click to install the ActiveX software.“Install”

-6--5-

Important information for the correct recycle/treatment procedures of
this equipment

The crossed-out wheeled bin symbol printed on the unit label or unit packaging indicates that
this equipment must not be disposed of as unsorted municipal waste but it should be

separately

. The waste of electric and electronic equipment must be treated separately, in
order to ensure that hazardous materials contained inside the equipment are not
buried thereby providing potential future problems for the environment and human
health. Moreover, it will be possible to reuse and recycle some parts of the waste of
electric and electronic equipment, contributing to reduce the quantities of waste
to be disposed of and the depletion of natural resources.
As user of this equipment, you are responsible to return this waste of
electronic equipment to an authorised collection facility set up by your
Municipality. More detailed information on your nearest collection centre
can be obtained from your Municipality or from other competent local
entities.
If you are replacing the old equipment with a new equivalent product, the
distributor must take-back the old equipment free of charge on a one-to
one basis as long as the equipment is of equivalent type and fulfilled the
same functions as the supplied equipment.
Your rôle in participating to the separate collection of waste of electric and
electronic equipment is essential to ensure that environmental protection
and human health objectives connected to a responsible treatment and
recycling activities are achieved.

PS.: The above mentioned information are reported herewith in compliance with Directive
2002/96/CE, which requires a separate collection system and specific treatment and
disposal procedures for the waste of electric and electronic equipments (WEEE). For
further and more detailed information, we invite you to visit our website at www.atlantisland.
com

4. NowyoucanuseyourNetCamerathroughthewebbrowser.

--7

collected