Atlantic Technology System 8200 Owners manual

System 8200 and 6200

Atlantic Technology

N N O V A T I V E

O M E

H E A T E R

Assembly Instructions

These Atlantic Technology Accent Panel Kits were designed to enhance

the appearance of System 8200 and 6200 speaker components, creat-

ing an attractive and elegant furniture look. This sheet will guide you

through the assembly process. Please follow each step carefully.

IMPORTANT NOTE:

As wood is a natural product there will

always be variations in the grain structure and coloration from

tree to tree, and therefore, from panel to panel. Atlantic Tech-

nology does not custom match Accent Panels and no guarantee

of matched panels is expressed or implied.

Also note that both Maple and Cherry woods will change their

color slightly as time passes. Maple takes on a golden glow as it

ages, while Cherry darkens in color. Long-term exposure to pol-

lutants, certain polishes, and sunlight can and will change the

color of natural woods as well.

Before attaching these panels to your Atlantic Technology compo-

nents, completely unpack the kits and check to insure you have all

the needed items.

We strongly recommend that you set up a safe place to attach the

Accent Panels to the enclosures. An open, carpeted area that won’t

scratch the panels and is large enough to allow turning the enclo-

sures over from side to side is best. If no such area is available, you

can use several bath towels, blankets, or other protective materials to

protect the enclosures and panels.

Installation

Remove the Accent Panels from their packing and put them

aside in a safe location. Find the Steel Mounting Clips and the

4 x 1/2 stainless steel #1 Phillips  at-head screws. These are to be

installed on the enclosure(s). You will  nd small pilot holes drilled

into the enclosures every place that a clip is to be mounted. Please see

the exploded diagrams on the opposite page for the Mounting Clip

locations of your particular enclosure(s). The clips must be placed

with the outer tab openings facing up when the enclosure is standing

upright (see the close-up diagram on the opposite page).

IMPORTANT NOTE:

speaker down on its side/front/back to install the clips as you

assistant hold the enclosure from the opposite side, both to

stabilize the assembly and allow you to apply adequate force

been bent.

will be attached to the enclo-

will slide into and mate with the clips you just installed on the enclo-

aligned and engaged before sliding the panel down.

paper, or a magazine. Use extreme care when installing the front

panel of the Pedestal Subwoofer to avoid damaging the IR Win-

should be taken into consideration when attaching the panels.

Accent Panel Care

with a liquid cleaner like Murphy’s Oil Soap or other similar product.

Accent Panel

Tools and materials needed for proper assembly (not included):

A good quality #1 Phillips screwdriver

A compact soft rubber mallet

Accent Panel Kits

Steel Mounting Clip

4 x 1/2 #1 Phillips