Atlantic Furniture AH10234 Assembly Guide
MISSION PRINTER STAND CHARGING STATION
ASSEMBLY INSTRUCTIONS
Before assembling your Printer stand, please read through these
instructions carefully and familiarize yourself with the different parts.
ATTENTION! If you receive a damaged or defective item,
please contact Atlantic Furniture at service@atlanticfurniture.com 1-800-955-3726 / M-F 9:00-5:00 EST
Hexagon Wrench
READY
TO
ASSEMBLE
Adult Assembly
NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE HEXAGON NUT, WASHER, WOODEN DOWEL,
Flat washer - 8 pcs Wooden Dowel 3/8 X 1 1/4” - 4 pcs
AE
Spare - 2 pcs
Hexagon nut - 8 pcs Wood Screw - 6 pcs
B
Spare - 2 pcs
OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.
Hexagon wrench - 1 pc
C
Wooden Dowel 1/4” X 1 1/4” - 4 pcs
D
Spare - 1 pc
Spare - 1 pc
F
Spare - 1 pc
PARTS LIST
01
TOP PANEL 1 PC
02
LEG
03
SIDE PANEL
04
LOWER SHELF
4 PCS
2 PCS
1 PC
01
02
02
02
02
03
03
MISSION PRINTER STAND CHARGING STATION
04
Page 1 of 3
STEP 1
Attach the legs (02) to the top panel (01) using flat washers (A) and hexagon nuts (B), tighten with
hexagon wrench (C), as shown below.
02
A
B
02
02
02
B
02
01
A
B
A
B
STEP 2 STEP 3
Install wooden dowels (D) and (E) into the locator
holes on (03) and (04) as shown below.
E
E
03
D
D
04
E
E
Attach first side panel (03) to printer stand aligning
the dowels (D) with the holes in the apron. Be sure
the panel is centered before tightening
the wood screw (F).
A
Adult Assembly
F
03
Repeat with the other panel.
note: panel in center
F
Adult Assembly
MISSION PRINTER STAND CHARGING STATION
D
D
Page 2 of 3
Loading...