Atlantic iceBar User Manual

Instruction Manual

Quick Start

Operation Guide

Troubleshooting

Care and Maintenance

P. 1 1

P. 2 1

P. 2 5

Introduction

Thank you for purchasing the iceBar . This product fits the iPod nano 1st

TM

R

Gen & 2nd Gen 1GB/2GB/4GB/8GB.
Designed to enhance your iPod experience, the

Repair

P. 5

P. 3 7

Warrant y

P. 3 9

Specifications

P. 4 7

Copyright

P. 4 8

iceBar gives you uninterrupted music in any
environment. Its design will protect your iPod from
sand, water and dust during usage. A tough
polycarbonate body with rubber bumpers ensures
shockproof protection. If used properly, the iceBar
will provide you with many hours of iPod enjoyment.

Copyright

TM

Apple and iPod are trademarks of Apple Computer, Inc. Registered in the

R

U.S. and other countries.

43

Parts List

Hand Strap with buoy floating device

Earphone Output Jack

iPod Nano Compartment

Click Wheel Membrane

Audio Switch

Power On / Off Switch

Battery Compartment

Red LED Status Indicator

Blue LED Power Indicator

O-Ring

iceBar

iPod Compartment Latch

3 x AAA Alkaline Batteries

Folding Stand

65

Safety Instructions

Please read and follow all safety and operating instructions before using this
product. Retain this manual for future reference.

Please observe all warnings on the product and in the operating instructions.

Do not take product apart for any reason. There are no user serviceable parts
inside, and any attempt at modifying or repairing your unit will void the
warranty. (See Warranty & Return Policy on page 39).

Do not apply excessive force to the controls, or put heavy objects on top of
the speaker. Keep sharp objects away from speakers.

Protect from direct sunlight and excessive heat. Avoid using the product for
long periods of time in hot temperatures. High temperature may damage
contents or shorten the life of sealing components. Do not store in closed
cars, etc.

7

Make sure unit is dry before opening and removing or accessing iPod.

Although the product is waterproof, it is not designed for use underwater. Do
not submerge underwater.

If water enters the iceBar to due to improper usage:

- Open the iPod nano compartment and remove batteries

- Drain water

- Dry interior with cloth

- Let the iceBar dry until mist and water droplets disappear.

Note: Failure to follow all safety instructions may void your warranty.

8

Safety Instructions (continued)

Avoid hearing damage - Permanent hearing loss may occur if earphones

are used at a high volume. Set the volume to a safe level. You can adapt
over time to a higher volume of sound that may sound normal but can be
damaging to your hearing. If you experience ringing in your ears or muffled
speech, stop listening and have your hearing checked. The louder the
volume, the less time is required before your hearing could be affected.
Experts suggest the following to protect one’s hearing:

- Limit the amount of time you use earphones at high volume.

- Avoid turning up the volume to block out noisy surroundings.

- Turn the volume down if you can’t hear people speaking near you.

For information about how to set a maximum volume limit on your iPod,
see the features guide for your iPod.

Safety Instructions (continued)

Using Earphones safely - Use of earphones while operating a vehicle is

not recommended and is illegal in some areas. Be careful while driving.
Cease from using iPod if you find it disruptive while operating any type
of vehicle or performing any other activity that requires your full
attention.

9

10

Before use, please REMOVE
SHIPPING RETAINER.

This piece must first be
removed before the iceBar
can be closed properly.
Failure to remove retainer
will result in water entering
inside of the iceBar and
possibly damaging
your iPod.

Remove

Remove before using

Enlevez avant utilisation

Quite antes de usar

Install Batteries

* New Alkaline batteries are recommended
* Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries

* Do not mix charged and partially charged batteries
* See battery safety rules on page 31.

1211

1. Align the audio port in your nano with the stereo jack in the iceBar housing.

2. Gently snap the nano into the audio jack. VERIFY the nano is COMPLETELY
plugged into the audio jack.

* The iceBar is specially designed for iPod nano 1st/2nd Generation. Forcing a
different player into the compartment will cause damage and void the
warranty.

Close the iPod compartment latch completely .

13

14

Attach the hand strap with buoy floating device to your iceBar. Controlling your iceBar

Power On / Off Switch

Attach the hand strap with buoy floating device to your iceBar. If it is difficult
to get the buoy strap through strap hole in the iceBar, we suggest using a piece
of dental floss or other thin string to help with this step. Use the thin string to
wrap around buoy strap and pull through strap hole, as shown above right.

15 16

Audio Switch