Page 1
Eclipse
444 CD / 200 DVD
Page 2
44
oT
Hex Key
oT
s includedlo
c
7
P
tneta
op s
É
ruos n
S.U
dnu .
dul
de
cni ton / dedeen slo
revirdwercs spillihP
reD
A
ne ohceH
reH
R1.1 070323 # 33335427
y
AU
E sol ed se
redna
odav
reseR sohce
b
r
ethceR ell
ov
F / anihC
rba
anihC ni tlletseg
rtxe sesíap
rejna
rtua te sinU statE ru
ap se
ne
P ehcsidnälsua e
ta
T
uo
/ s
rd s
netlahe
r stio
/ enihC ne éuqi
etimárt ne so
s
rté sy
egna
r
ignäh dnis et
g
resé
/ sév
4U
Page 3
U
2 - Screw (L) into panel (A). Insert dowels (M) and plastic inserts (U) into the holes as shown.1 - Insert (K) into side panels (E) and (F). Arrows should point towards screw opening, see diagram (1-A)
3 - Fasten (N) to panel (A) with screws (R). Insert pins (P) into the holes.
4 - Attach (E) and (F) onto panel (A). Lock by turning (K) in side panels (E) and (F), clockwise until it locks.
See diagram (4-A).
Page 4
U
5 - Slide middle panel (D) into groove in panels (E) and (F).
7 - Attach metal plates (O) to left door (G) and right door (H) with screws (S). 8 - Attach doors (G) and (H) to (A) and (B) with pins (P). Attach base panel (B) to side panels (E) and (F) with screws (Q).
6 - Insert dowels (M) into the holes of base panel (B) as shown. Insert plastic inserts (U) and then pins (P) into the
holes as shown.
Page 5
Hex Key
9 - Fasten rotating bracket (J) onto the lower base (C) with screws (T) using provided tool (Hex Key). 10 - Attach lower rotating base (C) to (B) by inserting and tightening screws (T) through access holes, one at a time.
11 - Insert pins (P) at desired heights. 12 - Place shelves (I) on pins (P).
Page 6
c
7
tneta
E sol ed se
P
ruos n
op s
É
dn
S.U
u .
reD
hce
A
hce
R ell
ne ohceH
reH
y
AU
redna
reseR so
odav
et
/ s
r
ov
b
netlahe
rba
F /
anihC
a
nihC ni tlletseg
R1.1 070323 # 33335427
rejna
rtxe sesíap
rtua te sinU statE ru
neta
P ehcsidnälsua e
T
r stio
uo
rd s
etimárt ne so
s
rté syap se
egna
r
g
ignäh dnis et
/ sév
resé
/ enihC ne éuqi
Loading...