Athena Wind N Go TimeMinder 7600 Operating Instructions Manual

Wind ‘N Go® TimeMinder™ #7600

IMPORTANT SAFEGUARDS

• Read all instructions before operating

• Do not look directly at the light; may cause injury

• Do not use in flammable or explosive environments

• Do not operate at temperatures above 120°F

• Avoid placing siren near the ears when using the siren

• To reduce the risk of electric shock, do not submerge the unit or its accessories in any liquid.

• Turn off radio, light and siren before charging

• For maximum battery efficiency, never completely deplete stored power

• Store in a clean dry place when not in use

• Administer close supervision when using around children

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the
following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

PARTS IDENTIFICATION

CHARGING THE RECHARGEABLE BATTERY

BEFORE FIRST USE, WE RECOMMEND CHARGING THE RECHARGEABLE BATTERY WITH THE USB ADAPTER.
Turn off all radio, light and siren features before charging. If the unit has not been used for more than 30 days it

is recommended that you recharge using an USB charger to recondition the rechargeable battery.

Dynamo Charging:

1.

Open the HAND CRANK and rotate steadily clockwise at approximately 120 cycles/minute for a minimum of
one minute. Longer wind-up times will yield a longer power duration. The blue backlight will appear on the LCD
DISPLAY during charging.

2. Close the

HAND CRANK

.

USB Charging:

1. Slide the CHARGING SELECTOR switch on the back of the unit to the left under TimeMinder icon.

2. Plug the INPUT/OUTPUT ADAPTER (the longer cord) into the OUTPUT/INPUT jack on the top of the unit and
plug the USB connector into a USB port of your computer or into a universal 5 volt DC USB charging device. The
blue backlight will appear on the LCD display during charging. NOTE: Only use a 5V USB power supply. Higher
voltage chargers may cause damage to the unit.

3. Allow 6-8 hours to achieve a full charge. To avoid damage to the battery, do not charge for more than 8 hours.

CHANGING THE REPLACEABLE BATTERIES

The replaceable batteries operate the clock, alarm and LCD features only.

1. Remove the CLOCK BATTERY ACCESS DOOR by removing 1 screw with a small Phillips head screwdriver.

2. Remove old batteries and replace as indicated on the battery door.

OPERATION

Setting the Time and Alarm:

1. To set the time, press and hold the TIME SET button while pressing the HOUR and MINUTE buttons until
the correct time is displayed.

2. To set the alarm time, press and hold the ALARM SET button while pressing the HOUR and MINUTE
buttons until your desired AM or PM alarm time is displayed.

3. To activate the alarm, press the ALARM ON/OFF button. An alarm clock icon will appear in the LCD
display to indicate that the alarm is activated. When the alarm goes off, the backlight will appear to display
the alarm time in the LCD screen. Press the ALARM ON/OFF button one time to turn off the alarm. The alarm
clock icon will continue to appear in the LCD display and is still set to go off at the same time the next day.

4. To deactivate the alarm, press the ALARM ON/OFF button a second time. The alarm clock icon will
disappear from the LCD display.

5. Before activating the alarm we suggest winding the unit for 1-3 minutes to ensure the backlight operates
during the night.

AM/FM Radio:

1. Turn on the radio by turning the VOLUME dial past the OFF position to the desired volume. The radio
station will appear in the LCD screen.

2. Select either the AM or FM band using the function switch on the top and tune to the desired station by
turning the TUNING dial.

Backlight: The backlight appears during charging, when the alarm goes off, or when the time/alarm or radio
functions are set. NOTE: To activate the backlight at any time, press the time set button.

3 LED Flashlight: Slide the LIGHT ON/OFF switch to the right or left for desired function.

Siren: Slide the function switch on the top to SIREN for a high-decibel emergency siren.

CELL PHONE CHARGING

1. Slide the CHARGING SELECTOR switch on the back of the unit to the right under the cell phone icon.

2. Plug the OUTPUT/INPUT ADAPTER, (the longer cord) into the OUTPUT/INPUT jack on the top of the unit
and plug the shorter CELL PHONE ADAPTER into your cell phone. A universal Nokia® adapter is provided.
Adapter tips for other model phones plug directly into the Nokia adapter. Additional tips are available at
electronic and mobile phone stores (not included).

3. Wind the hand crank for a minimum of 3 minutes to charge your cell phone battery. This method is
intended to provide enough power to make an emergency call only. It is not capable of fully charging your
cell phone.

TECHNICAL INFORMATION

SPECIFICATIONS

INTERNAL RECHARGEABLE BATTERY 3AA Ni-MH 3/6V 300 mA

CLOCK/ALARM BATTERY

USB DC UNIT CHARGING INPUT 5 Volt DC

WEIGHT 8 oz.

DIMENSIONS 4.38” L x 2” W x 2.5” H

2 Replaceable AGIO (expect 1 year usable life)

OPERATING TIMES

After winding for 3
minutes

Using the USB
charger to fully
charge

RADIO FLASHLIGHT CELL PHONE SIREN

30 minutes 60 minutes 2-3 minutes 60 minutes

6-8 hours 6-8 hours N/A - Function

only available with

wind-up

RADIO BANDS

AM 525 - 1710 Khz

FM 88 - 108 Mhz

3 hours

TimeMinder

OPERATING INSTRUCTIONS

™

7600inst; cs3/07

ATHENA BRANDS, INC.

Gardnerville, NV 89410 • 1-800-272-8603

www.athenabrands.com • [e-mail]