ATEN Technology IOGEAR RXGKM581R Users Manual

User Manual

1. Turn on the computer.

2. Insert two Ni-MH AA batteries into the battery compartment at the bottom of
the keyboard. Take care to insert the batteries in the correct polarity. Take out
the RF receiver and close the battery cover.

3. Plug the RF receiver into the USB port of your computer.

4. ID pairing:
a. Keep the distance between keyboard and Receiver within 1 meter.
b. Press the connect button at the front side of keyboard. Receiver LED
light flashes 3-5 seconds, then turns off, keyboard is synchronized, you may
enjoy the use.

Note:

1. RF signal LED on the receiver will flash when the keyboard is being used.

2. Battery Low indicator flashes red light, you need to charge the batteries.

Connect the keyboard to a available USB port on PC with the mini-USB
extension cable to charge batteries. During charging, Battery Low indicator
displays red light, it would become green light after the batteries are fully
charged.

3.In order to extend the batteries life, please charge for no lower than 8 hours

when you charge first time.

FCC WARNING

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

This device must be installed to provide a separation distance of at least 20 cm from
all persons and must not be collocated or operating in conjunction with any other
antenna or transmitter.

NOTE 1: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.

NOTE 3: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.