ATEN VE-RMK1U Quick Start Guide

ATEN Video Extender Rack Mount Kit

 1 x VE-RMK1U Frame
 4 x 1U Mounting Plates
 5 x Plastic Captive Screws
 6 x Hexagon Head Screws
 12 x Countersunk Head Screws

Note: Please make sure that all package
contents are present and that nothing is
damaged in shipping. If you encounter any
problems, contact your local sales
representative for more information.

Models

Mounting Plate

Category

Not Equipped with

Rack Ears

Equipped with

Rack Ears

Alignment

Line

Max. No.
of Units.

CE

CE100

-

Line A

4 units

VE

VE560, VE600A, VE602,
VE800A, VE803, VE810

VE601, VE801,
VE811, VE901

VE150A, VE170, VE172R,
VB802

-

Line B

3 units

1.

Align the device to its alignment line
as illustrated, latch one of the rack
ears onto the protruded dot on the
mounting plate, and secure the device
to the mounting plate using the
supplied hexagon head screw.

Example: VE801

2.

Position the VE-RMK1U frame on the
front of your rack, align the holes in
the frame with the holes in the rack,
and then secure the frame to the rack
with self-prepared screws.

3.

Follow the steps in Installing Devices to the Rack to finish the installation.

VE-RMK1U Quick Start Guide

Package Contents

Installation

Different ATEN devices use different sets of screw holes on the mounting plate to install. Use
the table below to find out:

 Whether if your ATEN device is built-in with rack ears
 The alignment line that your ATEN device uses

Note: For a full list of supported models, download the VE-RMK1U Installation Guide from the
VE-RMK1U web page.

Installing Devices with Rack Ears

Installing Devices without Rack Ears

1.

Align the device to line A.

Example: VE800A

2.

Secure the device to the mounting
plate from the backside using the
supplied countersunk head
screws.

Example: VE800A

3. F

Follow the steps in Installing Devices to the Rack to finish the installation.

1.

Align your device and mounting plate assembly to one of the slots on the VE-RMK1U
Frame.

2.

Secure the mounting plate to
the frame with a plastic captive
screw provided in the package.
For a device that aligns to line
A, you can install up to 4 units.

Installing Devices to the Rack

Published on May 29, 2020