ATEN UH-104, UH-107 User Manual

INTRODUCTION

Overview

The UH-104/UH-107 is an Universal Serial Bus (USB) hub,
which is a USB cable concentrator and a bridge between PC
USB Host Controller and USB devices. UH-104/UH-107 is a
full speed USB hub UH-104/UH-107 provides one upstream
port and four (or seven) downstream ports to user. It supports
both full speed (12M bps) and low speed (1.5M bps) devices,
such as keyboard, mouse, joystick and etc. UH-104/UH-107
provides both Self-powered and Bus-powered modes. UH­104/UH-107has per-port overcurrent detection LEDs, as well
as the per-port power ready LEDs for user. The detailed
specifications please refer to the section of "SPECIFICATION"

Features

• UH-104/UH-107 supports both OHCI (Open Host Controller
Interface) and UHCI (Universal Host Controller Interface).

•UH-104 provides four downstream ports; UH-107 provides
seven downstream ports.

• Both Self-powered mode and Bus-powered mode are
supported and the power mode is auto selected.

• Per-port overcurrent detection and protection.

• Per-port power ready and overcurrent LEDs indicators

• A real Plug & Play and Hot-plugged device.

Sample Diagram

POWER MODE SETTING

There are two power modes for UH-104/UH-107, one is the
Self-powered mode and the other is Bus-powered mode. For
Self-powered mode UH-104/UH-107 only provides all the

downstream ports with each port DC +5V, 500mA (max.) power

supply. For the Bus-powered mode, UH-104/UH-107 only
provides four downstream ports (port 1 to port 4). In Self­powered mode please make sure that the power adapter is well
installed and the plug of Power Adapter is inserted into the
Power Jack of the UH-104/UH-107. The powered mode is auto
selected while you insert ( or remove ) the plug of the power
adapter into ( or from ) the power jack of UH-104/UH-107.

Note : In the mode of cascading many UH-104 / UH-107 Hubs,

the upper layer of the Hubs must always be set into the
Self-powered mode. Only the lowest layer of the Hubs
can be set into Bus-powered mode.

System Requirement

(1) Windows 95 OSR 2.0 or Winows 98.
(2) Your PC must have USB Host controllers inside the

H/W system.

Description

Specification

POWER ADAPTER

The Power Adapter attached with the UH-104/UH-107 is DC 6V,
1A (min.) which is a minimum requirement for the device. If user
needs more power to supply the downstream port devices, user
can purchase a new Power Adapter with the Spec of DC 6V, 2A
or 3A. The mechanical of Power Adapter is listed in the follow
figure.

FUNCTION

Upstream Port (Root Port)
Downstream Port
Self-Powered
Bus-Powered
Downstream Power
Overcurrent Detection
Per-Port Voltage DC +5V
Per-Port Current 500mA (max.)
Operation Temperature
Stock Temperature
Humidity
Enclosure
Weight
Dimensions (LxWxH)

MODEL

UH-104 UH-107

1

4 7

1

1
4 7
4 7

4 4/7*
4 4/7*

5˚C ~ 40˚C

-20˚C ~ 60˚C

0% ~ 80% RH, noncondensing

Plastic

158g 178g

130 x 100 x 36.5 (mm)

Root Port

Power Jack
DC 6V

Port 5

Port 6

Port 7

Port 1

Port 2

Port 3

Port 4

Self-powered LED

Port 7

Port 1

Port 2

Port 3

Port 4

Per-port
power ready LED

Per-port
overcurrent LED

Bus-powered LED

Port 6

Port 5

Note* : UH-107 supports seven downstream ports only in Self-

powered Mode. Please refer to section of POWER
MODE SETTING

LED

Port 5 ~ Port 7 are UH-107 only

Power Plug

+6V

GND

5 mm

2.1 mm

PWR

OVR

PWR

OVR

Limited Warranty

IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE PAID FOR THE
PRODUCT FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK, OR ITS DOCUMENTATION.
The direct vendor makes no warranty or representation, expressed, implied, or statutory with
respect to the contents or use of this documentation, and specially disclaims its quality,
performance, merchantability, or fitness for any particular purpose.
The direct vendor also reserves the right to revise or update device or documentation without
obligation to notify any individual or entity of such revisions, or update. For further inquires
please contact your direct vendor.

Product Introduction

ATEN INTERNATIONAL CO., LTD.

12F, NO.101, Sung-Chiang Rd., Taipei, 104, Taiwan

TEL : [phone] FAX : [phone]

E-mail : [e-mail]

Manual Part NO. PAPE-1114-200

Printed in Taiwan 10/97

Install the Hardware

A. First of all, please insert the plug of the DC 6V 1A power

adapter into the power jack of UH-104 / UH-107.

B. Connect the series-A connector (please refer to the

Figures-1) of the USB cable into the downstream port of
PC USB host controller (or ROOT hub) or one downstream
port of the upper level (parent) hub.

C. Connect the series-B connector (please refer to the

Figure-2) of USB cable into the upstream port of UH­104/UH-107, the USB hub.

D. Connect the series-A connector of USB device, such as

Figure-1

Figure-2

INTRODUCTION

Series-A connectorSocket A

Series-B connectorSocket B

1 +VCC2 DM

4 GND3 DP

The most easily way to expand your PC system via parallel port and no
LPT por is occupied.
Include : for 2.3", 3.5" size Hard Disk and 5 1/4" size CD-ROM models.

The simplest solution for image duplication, cascade ability allows infinite
numbers of VGA monitors display the same image.
Include : 1 to 16 Rack mount 1U model, 1 to 2/4/8 desktop models, 1 to 5
for MAC users.

Enable one set of console, a keyboard, a monitor and a mouse, to control
multiple CPUs.
Includes : 1 to 2/4/6 models for PC/AT and PS/2 system and 1 to 4/8/16
Rack mount 1U or 2U models.

Enable multiple users to share multiple printers at the same time.
Include : Centronics ( parallel ) & PS-232 ( serial ) models and they can
be intermixed in a network.

The ability to convrter one type of signal to another.
A variation of the basic Auto Switch, in the mean time, sends data to

printer, which cuts delay and wait time.
Include : 2/4/8 to 1, 4 to 1/2 parallel models, buffer card has 256K, 1M,
2M bytes for your needed.

Let you share your peripherals.
Include : 2/4/8 to 1/2 bi-tronics may have file transfer, reversible, parallel
or serial, 4 to 1 for MAC models.
Bi-tronics parallel port has become a standard in the HP LaserLet IV
series. It is compatible with Centronics parallel, yet provides enhanced
features such as bi-directional communication higher data throughput and
printer control.
Reversible function help to solve the problem between multiple user and
pultiple peripherals at minimum cost.

Portable storage series

Video splitter series

CPU switch series

Printer network series

Converter series

Switch buffer series

Auto switch series

THIS PACKAGE INCLUDES

• One USB Hub UH-104 / UH-107

• One USB Cable (6 feet)

• One Power Adapter DC 6V ,(1A)

Please read this manual thoroughly and follow the instruction
procedures to prevent any damage to the UH-104 / UH-107 and
or the connecting devices.

©Copyright 1997 ATEN® International Co., Ltd.

All brand names and trademarks are the registered property of their respective owners.

USER'S MANUAL

5 +VCC

1 +VCC

6 DM

2 DM

7 DP

3 DP

8 GND

4 GND

PWR

OVR

Preventing Radio & TV Interference

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no quarantee that
interference will not occur in a particular installation.