ATEN IC-422 User Manual
User Manual
IC-422
Read this guide thoroughly and follow the installation and operation
procedures carefully in order to prevent any damage to the units and/or
any devices that connect to them.
This package contains:
M 1 IC-422PCI Card
M 1 User Manual
If anything is damaged or missing, contact your dealer.
®
© Copyright 2003 ATEN
Manual Part No. PAPE - xxxx-xxx
Printed in Taiwan 12/2003
All brand names and trademarks are the registered property of their respective owners.
International Co., Ltd.
2003-12-18
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and
used in accordance with the instruction manual, may cause
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
M Reorient or relocate the receiving antenna;
M Increase the separation between the equipment and
receiver;
M Connect the equipment into an outlet on a circuit different
from that which the receiver is connected;
M Consult the dealer or an experienced radio/television
technician for help.
2003-12-18
Overview
The IC-422 PCI card comes equipped with two High-Speed
RS-422/485 standard serial interface ports, each with 32 Bytes
of FIFO storage capacity and the ability to reach speeds of up
to 960 Kb/sec. The IC-422 provides two mini terminator block
type connectors for the attachment of four wire standard
telephone cable.
Features
2 Mini four wire terminal block connectors
M
40 Mbps max data transfer rate (250 K baud on networks of
M
up to 64 nodes)
Compatible with Win 98, ME, NT4, Win 2000/XP, Win 3.1,
M
DOS and Linux
- 1 -
2003-12-18
Loading...