Atec POGCS116-F User Manual

This test generator is designed to comply with the requirements of the MIL-STD 461 CS116.
The test method CS116 is used to verify the ability of the EUT to withstand sinusoidal excitation
on interconnecting cables. The pulse generator can be ordered with all the accessories in order
to build the full test set-up, consisting basically of an injection probe, an attenuator and an
oscilloscope. In addition to the basic requirements of the standard CS116, the number of
discrete frequencies is increased to 9 or 17 instead of 6. This allows a better excitation of the
resonances of the equipment under test. This generator has only one output and does not
require any change of connexion during the test. That feature greatly reduces the test duration.
The generator can be fully controlled by a computer through a RS232 or USB interface.

SPECIFICATIONS

Type POG-CS116-6 POG-CS116-9 POG-CS116-17

Frequencies

10, 100 kHz
1, 10, 30, 100 MHz

10, 30, 100, 300 kHz
1, 3, 10, 30, 100 MHz

10, 18, 30, 56, 100,
180, 300, 560 kHz
1, 1.8, 3, 5.6, 10,
18, 30, 56, 100 MHz

Standard

Output current

10 A on 100 ohm (depends on the frequency)

Output impedance

Damping factor

Repetition rates

Power rating

Generator weight

Dimensions

Other versions and other frequencies are available on request.

montena technology - 1728 Rossens - Switzerland - phone + 41 26 411 84 84 - fax + 41 26 411 17 79

www.montena.com e-mail: [e-mail]

MIL-STD 461 D / E / F CS116

< 100 ohm

15 +/- 5

single, 0.5 Hz, 1 Hz

210 - 250 Vac / 50 - 60 Hz / 35 W / 75 VA

21 - 23 kg

53 x 53 x 45 cm (L x W x H)