Atec E103 User Manual
Analyze • Detect • Measure • Control
TM
Technical Specifications
KeyTek ECAT
®
Model E103 Series Control Center
Computer-driven control center and power units required for the operation of any KeyTek ECAT test system
Virtual Front Panel™control 8 x 40 character keyboard entry & LCD display - allows operator to see
vital test parameters without list scrolling
FiberCom™fiber-optic Uses KeyTek ECAT software for full computer control of ECAT test equip-
interface & control system ment (user-supplied PC running Windows, 8 MB RAM, one serial port)
Module Bay For one full-width plug-in module or two half-width modules. Up to five
additional bays (for a total of six) and/or S-ECAT for floor-standing
system available (required for more than three docking bays)
Surge V & I monitor ports For waveform monitoring with an external (user-supplied) oscilloscope at
1kV/V and 200A/V;V & I signals supplied from optional AC coupler/
decoupler or KeyTek ECAT modules/options
Input voltage 100V to 240VAC, 50/60 Hz
Typical input current 3.5A @ 100V; 1.5A @ 240V
Operating temperature 15° to 35° C
Operating humidity 10% to 75% non-condensing
Options E103-S - adds oscilloscope trigger for installed surge modules
AC input connectors are available for most national and international standards.
Loading...