Atec AEMC-6416, AEMC-6417 User Manual

Clamp-On

Provides an extra

level of safety with

Ground Tester

Models 6416 & 6417

new Touch Voltage

indication feature

► Simple and fast clamp-on

operation - no leads, no
auxiliary rods or spacing
requirements

► Selectable test frequency

► Differentiates between

loop and ground resistance
measurements

► Android™ application

provides real-time data
review, geolocation and
e-mailing of test results

IP
40

Rated

► Automatic Hold function

► Displays stored

measurements visible
in direct sunlight and
in dark areas

► Storage of measurements

(Ω, A, V, alarms,
test frequency with
time-stamping)

Our products are backed by over 100 years of experience in test and measurement

equipment, and encompass the latest international standards for quality and safety.



Technical Hotline: [phone]



www.aemc.com

Test multi-grounded systems without disconnecting

the ground system under test!

The Ground Resistance Tester Models 6416 and 6417 measure ground rod and

grid resistance without the use of auxiliary rods. Clamp-on ground resistance testers

can be used in multi-grounded systems without disconnecting the ground system

under test or de-energizing them. Models 6416 and 6417 simply clamp around the

ground conductor or rod and measure the resistance to ground. By performing

measurements on intact ground systems, the user also verifies the quality of the

grounding connections and bonds. Resistance and continuity of grounding loops

around pads and buildings may also be measured.

Two new features unique to AEMC
voltage indication. The ability to select the test frequency provides more accurate

results in inductive environments. Displaying voltage derived from current and

resistance measurements provides an extra level of safety for the user, indicating

a potential dangerous touch condition. Both models include a current measurement

function. The probe’s high sensitivity enables measurement of leakage current

flowing to ground or circulating in ground loops from 0.2mA to 40A and resistances

from 0.01 to 1500Ω.

Both models offer battery life information at power-up and Auto-Off for power

management. Additional features are also displayed on the large OLED display to

ensure precise measurements. The Buzzer and Auto Power Off features may be

disabled from the push-buttons at any time.

Both offer an alarm function and a data storage function. In the Alarm mode,
the probe will audibly and visually indicate if the reading is beyond the user
programmed set point. The user may have the alarm activate above or below the

set point. This alarm feature permits quick field checks where only “pass”

or “fail” readings are required.

®

are test frequency selection and touch

IP
40

Rated

* *

*Model 6417 only

The data storage function enables the user to conduct field surveys, and to retrieve
and analyze the readings at a later time. The alarm settings and stored data are saved

when the ground tester is turned off. When using the FREE DataView
6417 provides Bluetooth transmission to a PC for analysis and report generation.

®

software, the

Now a simple solution to

read your measurements

Results, on the Go!

Model 6417 is available with an Android™

application for easy data programming,
downloading, printing and e-mailing test
results from your mobile device.

With its mobile GPS capability, users are now
able to easily locate the site associated with the
measurements.

2

www.aemc.com

Technical Assistance [phone]