Atec 7406-1 User Manual

MODEL 7054-1 SPIKE GENERATOR 600 volts

SPECIFICATIONS

Spike Amplitude: Continuously adjustable from

10 volts to over 600 volts peak.

Repetition Rate: Continuously adjustable from

0.8 to 10 p.p.s.

Rise Time: Less than 1.0 microsecond, into 5 ohm
resistive load.

Spike Duration: Output falls to zero in
approximately 10 microseconds.

Spike Shape: See curve. Similar to Figure 19 of
MIL-STD-462.

Phase Adjustment: Spike position adjustable
from 0° to 360° periodically on 50, 60 or 400 Hz
sine wave.

Internal Impedance: Less than 0.5 ohm.

Output Power: More than 300 kw peak into

0.5 ohm load.

Power Current in Series Injection Mode:

Handles up to 25 amperes of current at power
frequencies.

Power Requirements: 115 volts 60 Hz,

1.6 amperes. (230 volts 50 Hz, 0.8 ampere
available. )

Size:Standard rack panel: 7" high, 19" wide, 12.75"
deep.(17.78 cm x 48.26 cm x 32.38 cm.)

AVAILABLE ACCESSORIES

Type 7332-1 Transient Pulse Transformer. Plugs

into SERIES output terminals of 7054-1A to
provide spike levels up to 600 volts, peak, into
6 ohm load.

Type 7406-1 Transient Pulse Transformer.

Plugs into SERIES output terminals of 7054-1 to
provide spike levels up to 1200 volts, peak, into
50 ohm load.

Type 8525-1 Noninductive Five Ohm Load.

Type 8527-1 Transient Pulse Transformer. Plugs

into SERIES output terminals of 7054-1 to provide
spike levels up to 2 KV, peak,into 50 ohm load.

TRANSIENT SHAPE INTO FIVE OHM LOAD

REQUIRED BY MIL-STD-461A/462

SERIES INJECTION ON A.C. LINE

PARALLEL INJECTION ON D.C. LINE

24