ATD Tools ATD-8660 User Manual

ATD-8660
Digital Disc Brake
Caliper Instructions

3,

OPERATION

3.1.1

Ensure

at

least

3.1.2

Use

3.1.3

Press

•

WARNING!

all

measuring surfaces

one

second before use.

the

"mm/Inch"

the " Zero " button

Ensure

commencing

3.2

Measuring

3.2.1

To

3.2.2 Close

each

side

3.2.4

The

3.3

To

measure scored surfaces.

3.3.1 Close
anvil

in the

3.3.2

The

3.4 To

measure depth

3.4.1

Measure

3.4.2 Zero

3.4.3

The

Note:

If

the

withdrawn

Disk.

measure nnscored

the

caliper

of the

disk.

displayed reading

the

calipers

score,

displayed reading will

the

disc width next

the

reading

displayed reading will

disk

falls

from use and a new

button

that

and

zero

and

of

score.

and

measure

outside

are

to

at any

you

have read

surfaces.

the

reading. Place

will

be the

zero

the

be the

to the

the

be the

of

the

manufacturer's

replacement

clean

and

then turn

toggle

between

time

to

zero

the

and

understood

the

disk

width.

reading,

place

the

disk width inclusive

score

and

take a reading.

disk width with

score depth.

specifications,

meeting

on

caliper

inches

and

mm

at

reading.

Section I safety

callipers

jaws

so the

callipers either side

of the

score.

the

pointed anvils

it

should

the

manufacturer's

by

pressing "On" button. Wait

any

time.

instructions

anvils_make

the

disk with

in the

score.

not be

specifications

before

contact

the

machined

employed.

pointed

with

but

4.

BATTERY FITTING

Fitting a new

A flashing
exhausted - replace

iTRemove

lining

2.

Remove exhausted battery

with

+ve

3.

Dispose

manner.

If

the

minutes,

battery.'"""'"

display indicates that

as follows:

battery cover

the

lower edge.

side uppermost.

of old

battery

Do not

display fails

then

burn.

to

fit the

alter

batten-

J>1"

by

in a

'*"'"

sliding

and fit

safe

-when
again.

"n

"-'

"""""

the

battery

backward

replacement

and

approved

the

slide

is

and

is

moved, remove

the

battery, wait

for

around

3

NOTE:

data,

It is our

specifications

IMPORTANT:

policy

and

No

liability

to

continually

component

is

accepted

improve

parts

for

products

without

incorrect

and as

prior notice.

use of

product.

such

we

reserve

the

right

to

alter