ATD Tools ATD-8641 User Manual

ATD-8641

Hub Tool Instructions

2. Remove lug nuts and

wheel.

axle shaft.

Ford and Dodge 4WD Hub Tool

3. Remove manual locking
hub (This is a Warner Hub

Assembly).

4. Put two screws in as

shown. Push in to release

tension spring.

8. The hub is now removed.7. Pull the hub out.6. Remove snap ring from

1. 1999 Ford F-350 Pickup

Crew Cab Diesel 7.3 LTR

5. Remove spring clip.

9. Remove caliper and caliper

mount.

10. Support caliper to protect
brake hose using a bungee

cord or set on leaf spring.

14. Bearing assembly. 17. Reinstalled.

11. Remove the brake rotor.

15. When using either the

Dodge attachment, or the
Hub Tool alone, if the tool will
not thread on, turn the axle to

reposition the U-joint, then it

will thread on.

12. Remove the nuts holding
the bearing assembly. The

nuts are 21 mm thin wall

socket.

16. The U-joint had to be
turned out.

13. Turn steering wheel to the
right and tap on the tool. Turn
back to the left and tap again.

Go back and forth until the

bearing is removed.