ATD Tools ATD-6903 User Manual

ATD-6903

1.0MM TOUCH UP GUN W/CUP
INSTRUCTION MANUAL

Read this manual carefully and understand it completely.
Retain Manual for future use.

Always follow safety precautions to prevent personal injury and/or damage
to the equipment.

Illustrations and photos are intended for reference only. Actual product may vary.
Specifications are subject to change without notice.

Important Safety Instructions

1. Always wear eye protection, gloves and respirator to prevent against harmful
vapors while spraying.

2. Never use oxygen or any other combustible or bottle gas as a propellant.
Explosion and serious injury or death may result.

3. Many paints and solvents can be highly flammable. Please use the spray gun
only in well-ventilated areas, do not smoke or use near open flame.

4. Always disconnect the paint gun from air supply when not in use and during
maintenance. For emergency stopping and to prevent unintended operation, a
valve near the gun is recommended.

5. Inspect the tool before each use to ensure there is no leakage or misaligned
parts. Be sure the trigger moves freely.

6. Never use halogenated hydrocarbon solvent, as it can chemically react with
aluminum and zinc parts of this tool.

7. Do not make any modifications to this tool.

Figure 1:

1

Operating Instructions

POWER SOURCE

This tool operates best on a clean, dry supply of compressed air delivered at 29 to
50 psi. Use of a moisture trapping air filter is highly recommended as moisture or
foreign matter can damage the internal parts of this tool.

CAUTION: All air pressure in the system should be rated at 29 to 50 psi. Higher or
lower pressure can adversely influence the operation or cause damage to this tool.

NOTE: To maintain a maximum 10 PSI at the nozzle, use a maximum of 29 psi at
the inlet.

TOOL PREPERATION

1. Check tool for worn or damaged parts. Repair or replace as necessary.

2. Check trigger to ensure that it moves freely.

3. Connect tool to air supply.

4. Adjust air pressure based on paint viscosity and paint manufacturer’s

recommendation. (fig 2)

5. Clean paint guns before use, to ensure any factory oils or pigments are not present.

Do not use halogen hydrocarbon or acidic solvents to clean paint guns.

6. Pour paint into cup.

Figure 2:

GUN HANDLING

For best results, please follow these basic guidelines:

1. Keep the spray gun perpendicular to the surface. Spraying in an arc will not
give good results. (Fig. 3)

2.

Keep gun moving from one side to the other while spraying. If you stop

moving the gun while you are spraying, too much paint will build up and
begin to run. Begin the horizontal movement of the gun before you begin
spraying. Also, keep the gun at a constant distance 6-12 inches from the
surface. (Fig. 4)

2