IMPORTANT:
The "User Operating
Card" must be left with
Visidec Focus Articulated
Arm once installed.
Component Checklist
VF-AT-AA
Installation Instructions
Focus Accessory Arm
Hardware
M4x10mm
M4x12mm
Primary Arm
Cable Cover
M4x16mm
Articulated Arm
Hand Grip
Secondary Arm
Cable Cover
IMPORTANT INFORMATION:
! IMPORTANT - Install Visidec Focus Accessory Arm as per Installation Instructions.
! This product is designed to be installed onto an existing Visidec Focus pole mount.
! This products supports displays with a maximum weight of 8kg (17½ lbs), and VESA mounting hole configurations:
75 x 75mm (3" x 3"), 100 x 100mm (4" x 4").
! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Display Mounting
Screws
(4x)
(4x)
(4x)
Step 2. Remove Top Cap
Pole Top Cap
UP
Pole of the existing Visidec
Focus Product
Step 3. Attached Articulated Arm to the Existing Visidec Focus Product
Articulated Arm
Hand Grip tab
Pole
A. Slightly insert Articulated Arm.
B. Hold Articulated Arm at the lip
the pole and insert Hand Grip tab
in
the Articulated Arm.
Ensure the tab lines up with the slot
in the Pole.
Lip of the Pole
of
C. Slide down Articulated
Arm with Hand Grip to
the desired position.
D. Twist and lock the
Note: DO NOT
OVER TIGHTEN
Hand Grip.
Step 4. Fasten Display to Articulated Arm
Pull out
tabs
M4 Display Mounting Screws
For displays with 75 x 75mm
(3" x 3") mounting hole patterns
Step 5. Replace Top Cap
Step 6. Cable Management
Route the Cables underneath the Arms,
inserting the Primary and Secondary Arm
Cable Covers to hold the Cables in place.
- Ensure arm is fully extended
M4 Display Mounting Screws
For displays with 100 x 100mm
(4" x 4") mounting hole patterns
INSERT
To insert Cable Covers:
INSERT
Secondary Arm
Cable Cover
TIP:
Leave enough slack
in the cables at the joints
to allow full movement.
Primary Arm
Cable Cover
B. Push In
C. Then Push Up
NOTE: If the Articulated Arms are
Insert cables into the
pole slot using the
Cable Balls (supplied
with
the Visidec Focus
Mount) to hold them in
place.
INSERT
to be used in a multi-user
environment, use the Cable Clip
(supplied with the Visidec Focus
Mount) to secure the cables to
the pole.
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without noticed. Published 06.09.12
A. Insert Tabs
Loading...