Atdec TH-TVCD Installation manual
TH-TVCD
Component Checklist
Installation Instructions
Mobile TV Cart - Dual
Cross Beam
HARDWARE
M4 x 16/25
(x16)
M5 Washers
1/4” Washers
(x16)
(x12)
M5 x 16/25
(x16)
Spacers (x24)
Screen
Support (R)
Screen
Support (L)
M6 x 20/40/55
(x12)
Shelf Mounting
Bolt (M10)
Column
Mounting
Brackets (x4)
Shelf
M8 x 20/40/55
(x12)
Castor Spanner
Tools Required:
• Phillips Head Screwdriver
Castors (x2)
Locking Castors (x2)
Shelf Mounting Plate
Column Top Column Bottom Mounting Bracket
Cable Plug
M8 Button Screw
(x10)
21mm OD M8
Flat Washer (x10)
Allen Key
93mm OD
Washer (x2)
3/8” Washer (x2)
3/8” Spring
Washer (x2)
3/8” Bolt (x2)
Base
Extension Bracket (x8)
Rectangular Washer
(x8)
19mm OD M8 Flat
Washer (x16)
M8 Phillips Head
Screw (x16)
IMPORTANT INFORMATION:
! IMPORTANT - Install Telehook TV Cart as per installation instruction.
! This product supports a maximum load of 50kg (110lbs.)/Monitor.
! This product supports VESA Mounting Hole Configurations: From 200mm to 900mm wide
and from 200mm to 400mm high (600mm high with extensions).
! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Step 2. Assemble Base
Locking castors
2.1 Mount Locking castors to the front, Free
castors to the back and tighten with spanner.
Free castors
Castor Spanner
Step 3. Mount Column to Base
3.1 Ensure column
holes face the rear
of the base.
3.2 Line holes up
and secure column
to base.
M8 Button Screw
21mm OD M8
Flat Washer
Holes
3.3 Secure column
from beneath.
93mm OD Washer
3/8” Washer
3/8” Spring Washer
3/8” Bolt
Spanner
Step 4. Adjust Height Step 5. Mount Cross Beam
Note: Notch facing upwards
4.1 You can adjust the
height by moving the
tubes up or down before
fastening them.
M8 Button Screw
Allen Key
M8 Curved Washer
Step 6. Mount Screen Support
Tab facing upwards
Holes
5.1 Mount cross beam
onto column and fasten
with screws.
M8 Button Screw
Allen Key
C
L
C
L
Max Extension: 1310mm
6.2 Fasten screen support
to the cross beam and
repeat for the other side.
6.1 Slide screen support
into cross bar ensuring
holes face the centre.
21mm OD M8
Flat Washer
M8 Button Screw
Loading...