TH-PPA-18-25
Adjustor Pole
Component Checklist
Installation Instructions
18-25” (457-635mm) Adjustable Projector Pole Accessory
Adjuster Pole
Plastic Cover
Extension Pole
HARDWARE
Security Set Screw
(x2)
Security Socket Pan Head
Screw (x1)
Set Screw
(x2)
Standard Socket Pan Head
Screw (x1)
IMPORTANT INFORMATION:
! IMPORTANT - Install Telehook Adjuster Pole as per installation instruction.
! This product supports a maximum load of 454Kg (1000lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
Step 2. Configurations
18” Range 20-25” Range
4mm Security Allen Key
2.5mm Allen Key
2.1. Configure components as per image below for a pole length of
18”.
2.2. Screw Extension Pole in a clockwise direction into Ceiling Plate
Bracket.
Existing Ceiling
Plate Bracket.
(Sold seperately
and available from
ATDEC.)
Extension Pole
2.3. Configure components as per
image below for a pole length range of
20-25”.
2.4. Screw Extension Pole in a
clockwise direction into Ceiling Plate
Bracket.
2.5. Locate Adjuster pole on extension
Pole aligning the holes with the slot.
Extension Pole
Adjustor Pole
Existing Ceiling
Plate Bracket
Holes
Slot
Step 3. Assemble to desired length
3.2. Insert the one Standard or Security Socket Head Pan Screw through the slot
in the Adjuster Pole into either of the 2 visible holes in the Extension Pole. Each
hole enables a different length range.
Upper Hole
20”
22”
24”
Lower Hole
21”
23”
25”
3.3. Move the extension pole to the desired length and rotate to locate in one of
the three slots. Adjust the tightness of the screw using the 4mm Security Allen Key
supplied.
Step 4. Secure Position
4.1. When desired pole length has been selected use either the
Security or Set Standard Screws to secure position. Tighten with the
2.5mm Security Allen Key supplied.
4.2. Snap off bottom segment of cable cover for cable access.
Snap off
Cable
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 22.05.13 ©
Loading...