Atdec TH-PCP Installation manual

TH-PCP

Installation Instructions

Projector Ceiling Plate Accessory

Component Checklist

HARDWARE

Coach Bolt (x4)

Cover

Mount

Security

Allen Key

Security Set
Screw (x2)

Standard Set
Screw (x2)

M6 Washer (x4)

IMPORTANT INFORMATION:

! IMPORTANT - Install Telehook Ceiling Mount as per installation instruction.

! This product supports a maximum load of 100kg (220lbs.).
! The manufacturer accepts no responsibility for incorrect installation.

Step 1. Check Components

Check you have received all parts against the component checklist and hardware above.

Step 2. Ceiling Mount

Tools Required:

• Power Drill

• 4.5mm(0.18”) Drill Bit

• 10mm (3/8”) Socket Wrench Shifter

• Phillips Head Screw Driver

Timber Stud Masonry

Step 3.

2

Ø4.5mm x 65mm
deep Drilled Hole

NYLON ANCHORS

Mount

M6 Washer

Coach Bolt

TIP: Use Mount as a drilling template.

IMPORTANT! Any structural elements must be capable of

supporting the combined weight of all the equipment and devices
being mounted. If in doubt, consult a structural engineer.

NOT SUPPLIED

Step 4.

Secure pole by
inserting standard
or security set screws
using supplied Allen
key

2

Clip on Cover

Holes to Suit Anchors

Mount

M6 Washer

Coach Bolt

Step 5.

Side panels can be
snapped off to provide
cable route

1

Screw in 1.5 NPT Pole
(Available from ATDEC)

Installation Complete

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.

Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 21.03.13 ©