Page 1
Installation Instructions
TELEHOOK
32”-60” WALL FIXED
Important Notes
l
The Telehook 32-60 Wall Fixed supports LCD and Plasma Flat Panel Displays from 32” (81cm)
to 60” (152cm) and supports a maximum load of 91kgs (200lbs).
l
This product suits displays with mounting hole patterns from 180mm to 740mm wide (7”-29”) by 93mm to
500mm high (3
l
The manufacturer does not accept responsibility for incorrect installation.
Component Checklist
11
/
16
”-20 ”).
Bits B ag
Wall Plate
TOOLS REQUIRED:
l
Power Drill
l
12mm or 8mm Drill Bit
l
Phillips Head Screw Driver
l
Spirit Level
l
17mm (11/16”) Socket Wrench
or Shifter
A
Mounting the Wall Plate
Masonry Wall
Note: E nsure t he Wall Pl ate
is moun ted wit h the fol ded
tabs po intin g upward s.
Wall Plate
12mm (1/2”)
Hole
Display Bracke t (x2)
Secur ity Br acket (ri ght)
Secur ity Br acket (le ft)
TIP: Us e a spiri t
level to e nsure t he
wall pl ate is
horizontal
Masonry
Wall Plug
Coach S crew (x4)
Multi Washer (x4)
Mounting Screws
Cross Re cess Scre ws
Reces sed Hol e Bush (x4)
M8x15mm / M8x3 5mm / M8x45mm (x4 ea ch)
M6x15mm / M6x35 mm / M6x45mm (x4 each)
M5x15mm / M5x35 mm / M5x45mm (x4 each)
M4x15mm / M4x35mm / M4x45mm ( x4 each)
Timber Stud Wall
Note: E nsure t he Wall Pl ate
is moun ted wit h the fol ded
tabs po intin g upward s.
Wall Plate
Washer ( x4)
8mm (5/16”)
Hole
Masonry Wall Plug (x4)
Space r Bush (x4)
TIP: Us e a spiri t
level to e nsure t he
wall pl ate is
horizontal
Timb er
Stud
Coach S crew
Washer
Coach S crew
Washer
Page 2
B
C
Multi
Washer
Mounting
screw
M6 & M8
Screw H ole
M4 & M5
Screw H ole
When attaching the Brackets to the
display ensure that both
brackets are vertically aligned.
Ensure that the tightest fitting hole in
the multi washer is used
when attaching the mounting
screw to the display.
Recessed Mounting Holes
D
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 06.12.07 ©
Loading...