TH-3070-UFP
Component Checklist
Installation Instructions
Flat Screen Fixed Portrait Wall Mount
Tools Required:
• Power Drill
• 4.5mm(0.18”) Drill Bit
• 10mm(0.39”) Masonry Drill Bit
Wall Plate
Security Bar
Mounting Brackets (pair)
HARDWARE
M6 Coach
Bolt (x4)
Nylon
Anchor (x4)
M6 Washer (x4)
Big/Small
Spacer (x4/x8)
Rectangular
Washer (x4)
M5x14mm
M6x14mm/30mm
M8x20mm/30mm
Display Mounting
Screws (x4 each)
IMPORTANT INFORMATION:
! IMPORTANT - Install Telehook Flat Screen Portrait Wall Mount as per installation instruction.
! This product supports a maximum load of 70kg (154lbs.).
! This product supports Screen Mounting Hole Configurations: From 200mm to 600mm wide
and from 200mm to 400mm high.
! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Step 2. Attach Wall Plate to the Wall
Timber Stud Masonry Wall
Ø4.5mm x 55mm
deep Drilled Hole
M6 Washer
Coach Bolt
NOTE: Use a stud finder to accurately
locate the center of the stud. Ensure
that all screws fix securely into the stud.
Tips 1.Please use a Spirit Level to ensure plate is LEVEL.
2.Use the Wall Plate as a drilling template.
M6 Washer
Coach Bolt
Nylon Anchor
Step 3. Attach Mounting Brackets to Display in Portrait Position
Mounting Brackets
Slots
Display Mounting Screw
Washer
Ø10mm x 60mm
deep Drilled Hole
Use appropriate washers to level uneven
and recessed rear screen surfaces
Holes
Slots should be at the
top of the display
Back of Display
(Optional) Spacer
Step 4. Mount the Display to the Wall
Step 5. Security
Step 5a
Insert the Security Bar into
the slots on the Mounting
Brackets with the tab
facing outwards.
Angle the screen as
shown and position
so the hook is above
the bracket
Drop the hook
onto the bracket to
engage and gently
lower the screen
Slot
Step 5b
Security Bar
Secure with a Pad
Lock.
Pad Lock
(not supplied)
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 18.07.13 ©
Loading...