Atdec TH-3070-CTW-EXT-1M Installation manual

TH-3070-CTW-EXT-1M

Installation Instructions

Flat Panel Ceiling Mount | 1 Metre Extension

Component Checklist

Tools Required:

5mm allen key

Collar Joiner

IMPORTANT INFORMATION

! IMPORTANT - Install Telehook Flatpanel ceiling mount 1m extension as per Installation Instructions

! The Telehook Flat panel ceiling mount plus the 1metre extension supports a maximum of 91kg (200lbs).
! The installers should satisfy themselves that the ceiling is strong enough to support the Telehook Flat panel ceiling
mount unit of 14kgs (31lbs) and the 1m extension unit of 3kgs (6.6lbs) plus the maximum allowable monitor weight
of 91kgs (200lbs). Total of 108kgs (238lbs).
! The Manufacturer recommends the use of guy wires when adding the 1metre extension to an existing set-up
! The Manufacturer accepts no responsibility for incorrect installation.

1Metre Extension hanger

M8 x 10mm Screw

x12

Step 1. Check Components

Check you have received all parts against the Component Checklist and Hardware.

Step 2. Remove display mount

OR

Inner hanger

Extension hanger

Collar Joiner

Step 3. Add extension to set-up

OR

Inner hanger

New 1 Metre

Extension hanger

Add new extension
hanger and collar
joiner to set-up as
shown

Extension hanger

Collar Joiner

Display mount

Remove Display mount from existing set-up by
undoing the screws with a 5mm allen key.
Note: retain screws for further use with extension

New

Collar Joiner

Display mount

Step 3. Using Guy wires

3 Metre

(118.1”)

Maximum

Extension

Ceiling

ATDEC RECOMMENDS

the use of guy wires when
adding the 1metre extension
to an existing set-up

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.

Due to the continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 09.07.12 ©