Atdec TH-3060-UF User Manual

TH-3060-UF

Component Checklist

Installation Instructions

Flat screen wall mount | fixed

Hardware

M5x14mm (x4 )

Wall Plate

Left Mounting
Bracket

Tools Required:

Power Drill

•

•

5mm ( ”) drill bit

0.2

Phillips Head screwdriver •

•

10mm
10mm

(”)

masonry drill bit

0.39

(”)

0.39

Socket Wrench or Shifter•

Coach Screw (x4)

Right Mounting
Bracket

M6 Washer (x4)

M8 Spacer (x4)

Multi-washer (x4)

M5/M6 Spacer (x4)

Nylon Anchor (x4)

M6x14/30mm (x4 each)

M8x 20/30mm (x4 each)

Display Mounting

Screws

IMPORTANT INFORMATION

! IMPORTANT - Install Telehook 3060 Wall Mount as per Installation Instructions.

! This product supports a maximum load of 50kg (110lbs).
! This product only supports displays with mounting hole configurations from 100mm wide x 100mm
high up to 600mm wide x 400mm high.
! The manufacturer does not accept responsibility for incorrect installation.
! Before installing this Telehook product, please check the display ventilation requirements with your
LED/LCD manufacturer.

Step 1. Check Components

Check you have received all parts against the Component Checklist and Hardware above.

Step 2. Mounting the Wall Plate

Wall Plate

Coach Screw

M6 Washer

Masonry Wall

Nylon Anchor

Tip: Use the built-in spirit level to ensure wall plate is horizontal

10mm

0.39

(”)

depth: 55mm (2.2”)

hole

OR

Timber Stud

Note:

Use a stud finder to accurately locate the centre of

the stud. Ensure that all screws fix securely into the stud.

Timber Stud

5mm

(”)

hole

0.2

depth: 55mm (2.2”)

Wall Plate

Coach Screw

M6 Washer

Step 3. Attaching Brackets to Display

Right Mounting
Bracket

Mounting Screw

Multi-washer

Spacer
(optional, use only for
recessed mounting holes)

TOP

Left Mounting
Bracket

Step 4. Attaching/Detaching Display to Wall Plate (2 people required)

Lift your Display, hooking the Mounting
Brackets over the top of the Wall Plate Rail.
Pull down on the two Straps, and gently push
the bottom of the Display towards the Wall.
Release the Straps to engage the locking
mechanism, safely securing the Brackets to
the Wall Plate.

Note: Make sure the TV is correctly hooked before

releasing the Display.

HOOK

WALLWALL

Detaching Display from Wall Plate:

Pull down on both Straps to disengage the
locking mechanism. At the same time lift
the Display away from the Wall Plate.

Step 5. Hide Straps

If necessary, shorten
the length of the Straps
using the hook-and-loop
fastener strip, so that
they cannot be seen.

Installation Complete

PULL

Straps

SECURE

RELEASE

No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.

Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 30/10/2012 ©