Atdec TH-1026-VTP User Manual

TH-1026-VTP
Component Checklist
Installation Instructions
Flat Screen Wall Mount | Tilt
HARDWARE
M4x10mm/16mm
Spanner
M6 Coach
M4/M6 Washer
(x4 each)
Tools Required:
• Power Drill
• 4mm(0.15”) Drill Bit
TH-1026-VTP
(fully assembled)
• 8mm(0.3”) Masonry Drill Bit
• Phillips head screw driver
• 17mm(0.7”) Socket Wrench or Shifter
S8 Nylon
Anchor (x4)
Security
Screw (x2)
Display Mounting
IMPORTANT INFORMATION:
! IMPORTANT - Install Telehook Flat Screen Wall Mount as per installation instruction.
! This product supports a maximum load of 15kg (33lbs.). ! This product support VESA Mounting Hole Configuratons: 75x75mm and 100x100mm.
Also supports 200x100mm via additional adaptor plate AC-AP-2010 (sold separately). ! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Step 2. Hardware to Masonary Wall
Ø8mm x 50mm deep
Drilled Hole
Nylon Anchor
Coach Bolt
OR
Step 3a. Hardware to Timber Wall
Timber StudMasonry Wall
Ø4mm x 50mm deep
Coach Bolt
Drilled Hole
Clearance
M6x10mm/16mm
Screws (x4 each)
3-5mm
WALL
NOTE: Use a stud finder to accurately
Tip: Use the TH-1026-VTP Wall Plate as a drilling template.
locate the center of the stud. Ensure that all screws fix securely into the stud.
Step 3b. Attach Wall Plate to Timber Wall
Supplied Spanner
TIGHTEN
A. Attach TH-1026-VTP Wall Plate to the wall. B. Tighten the two coach bolts using the supplied spanner.
Step 4. Remove Mounting Plate
Mounting Plate
PULL-OUT
Step 5. Attach Mounting Plate to the Display
Display Mounting
TOP
Screw
Washer
Mounting Plate
Back of Display
Step 6. Mount the Display to the Wall
DISPLAY NOT SHOWN
INSERT
Mounting Plate with Display
Step 7. Fasten the Two Security Screws
Security Screw
FASTEN
Step 8. Tilt Adjustment Step 9. Pan Adjustment
-15°
DISPLAY NOT SHOWN
DISPLAY NOT SHOWNDISPLAY NOT SHOWN
+15°
TIGHTEN
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 04.12.12 ©
-30°
LOOSEN
+30°