ATC Toledo FPH1000T, Toledo FPH1500T, Toledo FPH2000T Installation, Operation & Maintenance Manual

FPH1000T
FPH1500T
FPH2000T

Toledo Panel Heater

INSTALLATION,

OPERATION &

MAINTENANCE MANUAL

Class I - IP 20

This Product is only suitable for well

insulated spaces or occasional use

1. IMPORTANT SAFETY INSTRUCTIONS

These instructions should be read carefully before installation and retained by
the user. The booklet must be kept and delivered to the new user in case of
change of ownership of the heater. The Manufacturer reserves the right to
vary the features of the product without prior notice. The technical data are
indicative only.

1. This heater is intended solely for the use it has been designed for, namely

space heating. The Manufacturer or Distributor is not responsible for any

damage that could happen due to improper use.

2. After unpacking, make sure that the heater is complete and shows no

signs of tampering or any visible damage. Should the unit be damaged please

return to the place of purchase.

3. Packing materials are potentially dangerous, keep away from children.

4. The heater can be used by children of at least 8 years of age (as well as by

persons with reduced physical, sensory or mental capabilities, or lack of

experience or required knowledge) provided that they are under supervision,

or after they have been instructed relating to the safe use and have

understood the potential dangers. Children should not play with the Heater.

5. Cleaning and maintenance must be performed by the user and not by

unsupervised children.

6. Children aged between 3 and 8 years of age shall not plugin, regulate, clean

the heater or perform maintenance. Children of less than 3 years should be

kept away unless continuously supervised.

7. Children aged from 3 years and less than 8 years shall only switch on/off the

heater provided that it has been placed in its intended normal operating

position and they have been given instruction concerning use of the heater

in a safe way and understand the hazards involved. Children should always be

supervised.

8. Before connecting the heater make sure that the voltage is the same as

indicated on the device rating label.

9. Do not use in presence of gas, inflammable or explosive liquids or substances

as defined in BS5345.

10. Some fundamental rules which apply to all electrical devices must be observed

when using the heater:

• Do not touch the heater with wet hands.

• Do not handle the heater when you have bare feet.

• Do not let children play with the heater.

11. Avoid the use of extension cords with this product, extension cords may

overheat and there could be a risk of fire.

12. Do not make any modification to the Heater.

13. Keep connections dry.

14. If the power supply cord is damaged, do not use the heater until the cord has

been replaced. For power cord replacement, always contact an electrician in

order to avoid any risk of injury.

15. If the heater is not going to be used for a long period, disconnect it from the

power supply.

16. Always disconnect the heater before doing any maintenance

CAUTION - Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and vulnerable
people are present.

2. ELECTRICAL INSTALLATION NOTES

The installation should always be carried out by a qualified electrician or

a competent person in accordance with the current electrical standards:

HD 384 CENELEC for Mainland Europe, IEC 60446 and BS 7671 for the

United Kingdom, IEC 60445(2010) & ET101:2008 for Ireland and IEC 60364-7-708 1988

Internationally. The energy supply to the heater must always be properly earthed. The

heater must be connected to the energy supply using the provided cable.

An overvoltage category III Combined Circuit breaker and Residual
Current Device (RCD) with rated earth leakage operation not exceeding
30mA must be fitted upstream on the supply line. The circuit breaker
must have a contact opening distance of at least 3 mm.

• The heaters should always be used with the mounting feet provided

• Under no circumstances turn the heater on if it is not mounted using the Feet

supplied or if the face of the heater is on any surface.

• The heater must not be recessed in the ceiling. There must be enough space

around the top of the heater to ensure adequate ventilation.

• A minimum air gap of at least 90 cm should always be allowed between the top

of the heater and a ceiling or roof.

• A distance of at least 100 cm should always be left in front of the heaters to

ensure safety

• The Heater must not be located either directly below, or in front of a socket-

outlet.

• The heater must not be used in a bathroom.