ATBS Technology AT63 Users Manual

AT63 sensor User’s guide

Model

Photograph

AT63 sensor

Battery

Lock nut

Wrench

Userguide

1. Introduction

This AT63 BLE sensor is a type of sensor that
combined TPMS and cellphone. AT63 TPMS external
sensor adapts BLE low energy transmission, let driver
understand tire situation through cellphone. When the
system detects tire pressure or temperature abnormal
situation, it (APP) will directly alarm the driver.

About This Manual：

 The information in this manual is subject to change

without notice.

 This manual has been created with extra care. In case

that you have any comments or questions regarding
this manual, please contact your local dealer or our
Customer Service Center.

 Before operating this set, please fully understand the

prerequisite such as specifications or constraints of
the hardware and software. We are not responsible
and have no liability for any loss, damage or injury as a
result of misuse.

2. Check Accessories

3. System installation

3.1 Install sensor(battery changeable)

3.1.1 Place batteries into the sensor and screw the top
cap off. Please attend to the electrode of the battery.

Copyright (C) ATBS Technology Co. R7 版權所有請勿翻印

3.1.2 Remove original valve cap and screw lock nut (1)
and will become (2). Screw the Sensor onto valve stem
clockwise (3). Screw (1) lock nut back and use wrench

to lock tightly (4). (3)(4) steps could effectively prevents

sensor from removing.

3.1.3 The sensor label already indicates the sensor ID
and its wheel order, please follow the wheel order to
install sensors.

EX :

Sensor Model: AT63
ID:810C619A

Note：
(1) Beware of the conductivity between the sensor
and valve stem.
(2) Sensors are supposed to be well locked valve

stem to avoid from leaking.

(3) Please replace original manufacturer’s sensor

battery in case voltage is below 2.7v.

(4)External sensor will transmit data every 58~62

seconds when the vehicle is running, and when
the vehicle stops, the sensor will transmit data
every 148~152 seconds.

4. iTPMS APP Installation:

iTPMS App is for free. Through the iTPMS you can know
tire temperature and pressure, sensor battery voltage,
and each sensor’s ID.

4.1 Install APP (Take IOS as example)

4.1.1 Download the APP: iTPMS BLE from Apple Store or
Google Play.

4.1.2 Go to Setting => General => Bluetooth Page.

4.1.3 Turn on the Bluetooth

4.1.4: Turn on the Bluetooth, and it will scan the devices
automatically.

4.1.5 Install battery properly, and then enter to the sensor

ID s etting pages. After setting the ID properly, it will
read the tire data immediately.

4.2 App Operating

4.2.1 Click below ID, and enter the ID learning page, start
to learn the sensor ID.

Note: When the above BLE words light up, then it
represents it detects AT63’s signal already.

4.2.2 Place batteries into the sensor properly. When

sensor detects pressure, ID will turn to red to alert the
user.

4.2.3 Enter Setup page, users can set up the unit and limit

of tire pressure and temperature.

Copyright (C) ATBS Technology Co. R7 版權所有請勿翻印