This device complies with FCC Rules Part 15. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! The use of a shielded-type power cord is required in order to meet FCC
emission limits and to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded
cables to connect I/O devices to this equipment. You are cautioned that changes or
modifications not expressly approved by the party responsible for compliance could
void your authority to operate the equipment.
Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC:
Office of the Federal Register, National Archives and Records Administration, U.S. Government Printing Office.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For use with AC Adaptor Model ADP-45GB (Pour Utiliser Avec Modele ADP-45GB)
2
Nordic Cautions for Lithium-Ion Battery
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions. (English)
VORSICHT! Explosionsgetahr bei unsachgemäßen Austausch der Batterie. Ersatz
nur durch denselben oder einem vom Hersteller empfohlenem ähnlichen Typ.
Entsorgung gebrauchter Batterien nach Angaben des Herstellers. (German)
ADVARSELI! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning
må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til
leverandøren. (Danish)
VARNING! Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en
ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri
enligt fabrikantens instruktion. (Swedish)
VAROITUS! Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo
ainoastaan laitevalmistajan sousittelemaan tyyppiin. Hävitä käytetty paristo valmistagan
ohjeiden mukaisesti. (Finnish)
ATTENTION! Il y a danger d’explosion s’il y a remplacement incorrect de la batterie.
Remplacer uniquement avec une batterie du mêre type ou d’un type équivalent
recommandé par le constructeur. Mettre au rebut les batteries usagées conformément
aux instructions du fabricant. (French)
ADVARSEL! Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype
eller en tilsvarende type anbefalt av apparatfabrikanten. Brukte batterier kasseres i
henhold til fabrikantens instruksjoner. (Norwegian)
(Japanese)
UL Safety Notices
Required for UL 1642 covering primary (nonrechargeable) and secondary (rechargeable)
lithium batteries for use as power sources in products. These batteries contain metallic
lithium, or a lithium alloy, or a lithium ion, and may consist of a single electrochemical cell
or two or more cells connected in series, parallel, or both, that convert chemical energy
into electrical energy by an irreversible or reversible chemical reaction.
• Do not dispose the Notebook PC battery pack in a fire, as they may explode. Check with
local codes for possible special disposal instructions to reduce the risk of injury to persons due to fire or explosion.
• Do not use power adapters or batteries from other devices to reduce the risk of injury to
persons due to fire or explosion. Use only UL certified power adapters or batteries supplied by the manufacturer or authorized retailers.
3
English
Safety Precautions
WARNING! The following safety precautions will increase the life of the Notebook
PC. Follow all precautions and instructions. Except as described in this manual, refer
all servicing to qualified personnel. Do not use damaged power cords, accessories, or
other peripherals. Do not use strong solvents such as thinners, benzene, or other
chemicals on or near the surface.
Disconnect the AC power and remove the battery pack(s) before cleaning. W ipe the Notebook PC using a clean cellulose sponge or chamois cloth dampened with a solution of
nonabrasive detergent and a few drops of warm water and remove any extra moisture with
a dry cloth.
DO NOT place or drop objects
on top and do not shove any
foreign objects into the Notebook PC.
DO NOT press or touch the display panel. Do not place together with small items that may
scratch or enter the Notebook
PC.
DO NOT expose to dirty or
dusty environments. DO NOT
operate during a gas leak.
DO NOT expose to strong
magnetic or electrical fields.
DO NOT expose to or use near
liquids, rain, or moisture. DONOT use the modem during an
electrical storm.
DO NOT expose to extreme
temperatures above 50˚C
(122˚F) or to direct sunlight.
Do not block the fan vents!
DO NOT expose to extreme
temperatures (below 0˚C
(32˚F), otherwise the Notebook PC may not boot.
DO NOT throw batteries in
fires as they may explode.
Check local codes for special
battery disposal instructions.
4
MP3 Player Driver Setup
5
English
MP3 Player Driver Setup
Installing the MP3 Player Driver for Windows ME
Installation is different for Windows ME and 2000. Find the Windows 2000 steps
after Windows ME. Insert the support CD and follow the steps below to install the MP3
Player driver.
M
(1) With the MP3 module inserted,
press and release the play button.
(2) Windows will display “New Hard-
ware Found” and begin the driver
installation wizard.
(4) Enter the path “__\MP3\Driver” (with the letter of your CD drive) or use the
Browse button and click Next.
(3) This installs the first driver. Select
“Specify the location...” and click
Next.
6
MP3 Player Driver Setup
Installing the MP3 Player Driver for Windows ME (Cont’)
(5) Click Next when the driver is lo-
cated by Windows.
(6) Installation is finished. Click Fin-
ish to exit.
(+) The MP3 player module drivers
will be shown under “Universal
Serial Bus controllers”
7
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.