Page 1
INSTRUCTIONS
FOR
YOUR
PRODUCT
Step 1
Place the pump
inside the pipe and
pull power cord out
through the bottom.
Thank y
of this hand-crafted garden fountain.
We have taken great care to create
this piece especially for you. Please
review these instructions and
assemble this piece with care.
ou for your recent purchase
Step 2
Connect the pump
to the tubing located
on the cover. Place
cover on top of pipe.
Step 3
Fill the reservoir with water
to completely submerge the
pump and take a note of the
level that the water reaches
for future reference when
topping off.
Step 4
Plug in pump. After a short
while the water will start to
flow. Add water as needed.
Adjust the pump flow rate to achieve
the desired effect and to minimize
any splashing. Splashing can occur if
the flow rate is too high or the feature
water level is too full. The flow rate can
be increased or decreased by moving
the flow rate control slider on the pump
body. Moving the switch towards
(+) will increase the flow rate and
moving it towards (-) will decrease it.
WARNING:
Never turn on the pump before the
fountain is full of water. Also do not
let the water level fall below the top
of the pump as the pump will become
damaged if ran without water. Fountain
should be placed on a level surface.
T H A N K YOU
P U R C H A SE
YOUR
FOR
Loading...