Aperio
AH40
®
Hub Installation Guide
Experience a safer
and more open world
1
AH40 - Table of Contents
AH40 - FCC and ISED Canada Statements ......................................................... 3
AH40 - Placement of Communication Hub ..................................................... 5
AH40 - Mounting, Americas Adapter Plate ...................................................... 6
AH40 - Mounting, Bottom Cover ......................................................................... 7
AH40 - Connectors ................................................................................................... 8
AH40 - Jumpers.......................................................................................................... 9
AH40 - Communication Hub LED Indications ...............................................10
AH40 - Technical Data ..........................................................................................11
Conforms to EN 62368-1 and UL/CSA 62368-1
2
AH40 - FCC and ISED Canada Statements
FCC Statements
Changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void the users authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
ISED Canada Statements
This radio transmitter [IC:9504A-AH40R03] has been approved by Innovation,
Science and Economic Development Canada to operate with the antenna types
listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated
for any type listed are strictly prohibited for use with this device.
Antenna type Maximum antenna gain (dBi) Impedance (ohm)
Internal antenna 3.6 50
AH-ANTENNA-1 2.15 50
3
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le present émetteur radio [IC:9504A-AH40R03] a été approuvé par Innovation, Sciences et Développement économique Canada pour fonctionner avec les
types d’antenne énumérés ci dessous et ayant un gain admissible maximal. Les
types d’antenne non inclus dans cette liste, et dont le gain est supérieur au gain
maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour
l’exploitation de l’émetteur.
Type d’antenne Gain d’antenne maxima (dBi) Impédance (ohm)
Antenne interne 3.6 50
AH-ANTENNA-1 2.15 50
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
4