ASSALOY AH40R02 User Manual

Aperio® Hub
AH40
Installation Instructions

ASSA ABLOY, the global leader
in door opening solutions

1

AH40 - Table of Contents

AH40 - FCC and Industry Canada Statements 3

AH40 - Placement of Communication Hub 4

AH40 - Connectors 5

AH40 - Jumpers 6

AH40 - Communication Hub LED Indications 7

AH40 - Technical Data 8

ETL marking

Recognized component

4002570

Conforms to ANSI/UL standard 294, ANSI/UL 60950-1
Certified to CAN/CSA standard C22.2 No. 60950-1

For more detailed information about the Aperio system please read
ST-001279-Aperio Technology Installation Guide AH40.

2

AH40 - FCC and Industry Canada Statements

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be deter­mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules and with RSS-210 of ISED. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.

Le présent appareil est conforme aux CNR d’ISED applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes:

1. l’appareil ne doit pas produire de brouillage, et

2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.

The term “IC:” before the equipment certification number only signifies that the Innova­tion, Science and Economic Development Canada technical specifications were met.

Le terme “IC” devant le numéro de certification signifie seulement que les
spécifications techniques Innovation, Sciences et Développement économique Canada

ont été respectées.

FCC Caution: Any changes or modifications not expressly approved by the party respon­sible for compliance could void the user’s authority to operate this equipment.

This radio transmitter (IC: 9504A-AH40R02) has been approved by ISED to
operate with the antenna types listed below with the maximum permissible gain
indicated.

Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.
Antenna type: ASSA ABLOY AH-ANTENNA-1, max gain 2,15 dBi.

Le présent émetteur radio (IC: 9504A-AH40R02) a été approuvé par ISED
pour fonctionner avec les types d’antenne énumérés ci-dessous et ayant un gain
admissible maximal. Les types d’antenne non inclus dans cette liste, et dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour l’exploitation de
l’émetteur. D’antenne énumérés: ASSA ABLOY AH-ANTENNA-1, Gain maximal indiqué
2,15 dBi.

3

AH40 - Placement of Communication Hub

< 15 m / ~ 50 ft

Example of placement of the Hub with 8 locks. AH40 can
manage up to 16 locks.

Note: AH40 Communication hub must be installed into a
junction box ex European 2-Gang, Aperio bottom cover or with
Americas adaptor plate to junction box. AH40 must be installed
by qualified and trained personal. Indoor installation only!

Note: The Aperio Communication hubs are not rated to be

installed in the plenum space.

4