ASSALOY AH20R03 Users manual
Aperio
®
AH20/AH30
Hub Installation Guide
Experience a safer
and more open world
1
AH20/AH30 - Table of Contents
AH20/AH30 - FCC and ISED Canada Statements ............................................ 3
AH20/AH30 - Placement of Communication Hub ......................................... 5
AH20/AH30 - Mounting, Americas Adapter Plate .......................................... 6
AH20/30 - Mounting, Bottom Cover .................................................................. 7
AH20 (J101) - Connections ................................................................................... 8
AH20 Advanced Wiegand (J100) - Connections ..........................................10
AH20 - DIP Switch Configuration Table (S700).............................................11
AH30 (J101) - Connections ................................................................................12
AH30 - DIP Switch Configuration Table (S700).............................................13
AH30 - RS485 Bus Connection ...........................................................................14
AH30 - RS485 Addressing ....................................................................................15
AH20/AH30 - Communication Hub LED Indication ....................................17
AH20/AH30 - Technical Data ..............................................................................18
Conforms to EN 62368-1 and UL/CSA 62368-1
2
AH20/AH30 - FCC and ISED Canada Statements
FCC Statements
Changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void the users authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
ISED Canada Statements
This radio transmitter [IC:9504A-AH20R03] has been approved by Innovation,
Science and Economic Development Canada to operate with the antenna types
listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated
for any type listed are strictly prohibited for use with this device.
Antenna type Maximum antenna gain (dBi) Impedance (ohm)
Internal antenna 3.6 50
AH-ANTENNA-1 2.15 50
3
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le present émetteur radio [IC:9504A-AH20R03] a été approuvé par Innovation, Sciences et Développement économique Canada pour fonctionner
avec les types d’antenne énumérés ci dessous et ayant un gain admissible
maximal. Les types d’antenne non inclus dans cette liste, et dont le gain est
supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont
strictement interdits pour l’exploitation de l’émetteur.
Type d’antenne Gain d’antenne maxima (dBi) Impédance (ohm)
Antenne interne 3.6 50
AH-ANTENNA-1 2.15 50
L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
4
AH20/AH30 - Placement of Communication Hub
< 25 m / ~ 80 ft
AH20/30 - Placement of the Hub, 1 door
Note: AH20/AH30 can be installed with an Aperio bottom cover or
Americas adapter plate.
< 25 m / ~ 80 ft
AH30 (RS485 Hub) - Placement of the Hub, 1-16 doors
Note: AH20/AH30 must be installed into a junction box ex
European 2-Gang, Aperio bottom cover or with Americas adapter
plate to junction box. AH20/AH30 must be installed by qualified
and trained personal. Indoor installation only!
5
AH40 - Mounting, Americas Adapter Plate
AH20/30 - Mounting, Americas Adapter Plate
(US version)
1
3 4
Screw
(3 x 10 mm)
5
Americas
Adapter
Plate
Screw
(4 x 35 mm)
Option
2
Top Cover
External
Antenna
6
Loading...