ASSALOY AH20R02 User Manual

Aperio® Hub AH20/AH30 Installation Instructions

ASSA ABLOY, the global leader in door opening solutions

AH20/AH30 - Table of Contents

AH20/AH30 - FCC and Industry Canada Statements 3

AH20/AH30 - Placement of Communication Hub 4

AH20 (J100) - Connections 5-6

AH20 (J103) - Connections 7

AH20 - DIP Switch Configuration Table 8

AH30 (J100) - Connections 9

AH30 - DIP Switch Configuration Table 10

AH30 - RS485 Bus Connection 11

AH30 - RS485 Addressing 12-13

AH20/AH30 - Communication Hub LED Indication 14

AH20/AH30 - Technical Data 15

ETL marking

Recognized component

4002570

Conforms to ANSI/UL standard 294, ANSI/UL 60950-1 Certified to CAN/CSA standard C22.2 No. 60950-1

AH20/AH30 - FCC and Industry Canada Statements

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.L’exploitation est autorisée aux deux conditions suivantes:

1. l’appareil ne doit pas produire de brouillage, et

2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

The term “IC:” before the equipment certification number only signifies that the Industry Canada technical specifications were met.

Le terme “IC” devant le numéro de certification signifie seulement que les spécifications techniques Industrie Canada ont été respectées.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This radio transmitter (IC: 9504A-AH20R02) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna type: ASSA ABLOY AH-ANTENNA-1, max gain 2,15 dBi.

Le présent émetteur radio (IC: 9504A-AH20R02) a été approuvé par Industrie Canada pour fonctionner avec les types d’antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d’antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l’exploitation de l’émetteur. D’antenne énumérés: ASSA ABLOY AH-ANTENNA-1, Gain maximal indiqué 2,15 dBi.

AH20/AH30 - Placement of Communication Hub

< 15 m / ~ 50 ft

AH20/30 - Placement of the Hub, 1 door

Note: AH20/AH30 can be installed with an Aperio bottom cover or Americas adaptor plate.

< 15 m / ~ 50 ft

AH30 (RS485 Hub) - Placement of the Hub, 1-8 doors

Note: Note: AH20/AH30 must be installed into a junction box ex European 2-Gang, Aperio bottom cover or with Americas adaptor plate to junction box. AH20/AH30 must be installed by qualified and trained personal. Indoor installation only!

Note: The Aperio Communication hubs are not rated to be

installed in the plenum space.

AH20 (J100) - Connections

S100

K500 K501 K502 K503

NCL1

COM1

NOP1

NCL2

COM2

NOP2

NCL3

COM3

NOP3

NCL4

COM4

NOP4

J103

1 2 3 4 5 6 7 8 9 10

RED

S101

GREEN

GND

8-24V

J100

AH20 Advanced Wiegand Connectors (J100)