Asrock SUSB 3.0 QUICK START GUIDE

ASRock USB 3.0 Card Quick GuideASRock USB 3.0 Card Quick Guide

ASRock USB 3.0 Card Quick Guide

ASRock USB 3.0 Card Quick GuideASRock USB 3.0 Card Quick Guide

I. IntroductionI. Introduction

I. Introduction

I. IntroductionI. Introduction

ASRock USB 3.0 Card allows you to enjoy the high speed data transfer rate up to

5.0 Gb/s, which is ten times faster than current USB 2.0 device (480 Mb/s). With
two USB 3.0 ports on ASRock USB 3.0 Card, you can have a more flexible option
to upgrade the USB data transfer rate for your motherboard. Therefore, on this
basis of the advantageous data transfer speed and the facilitating mobile
capability, USB 3.0 may replace other devices to become a trend for external
interface.

USB 3.0 Ports:

Connect USB 3.0
devices to USB 3.0
ports.

II. InstallationII. Installation

II. Installation

II. InstallationII. Installation

Before you install ASRock USB 3.0 Card on your motherboard, please refer to
below steps carefully.
Step 1. Insert ASRock USB 3.0 Card into PCIE slot on ASRock motherboard. Please

make sure to disconnect power supply before installing or removing
ASRock USB 3.0 Card.

Step 2. Boot your system and install ASRock USB 3.0 Card driver from ASRock

support CD. ASRock USB 3.0 driver is located in the following path of
ASRock support CD:

..\Drivers\USB3.0\NEC\Win7-64_Win7_Vista64_Vista_XP64_XP
(v10170)\NECEL-USB3-Host-Driver-10170-setup.exe

Step 3. Restart your system. Then you can freely enjoy the convenience of

ASRock USB 3.0 Card.

* Whether USB legacy can work depends on the system motherboard BIOS support.

3V_DUAL_POWER Jumper:

Short pin1, pin2 to enable USB Wakeup.
Short pin2, pin3 to disable USB Wakeup
to meet EuP standard.