Instructions for use
Gas hob
HG1355gd / HG3ADE1A
HG1365gd / HG1BDE1A
EN Manual EN 3 - EN 9
Before use, read the separate safety
instructions first!
Pictograms used:
Important information
Tip
OPERATION
Description
4
2
3
1. rapid burner
4
7
3
1
2. wok burner
3. pan support
4. glass top
5. wok selector ring
6. control knob
7. standard burner
Top view of appliance
6 65
Ignition and adjustment
2
3
4
1
2
3
5
6
1
1. zone indication
2. 0 position
3. High setting
4. Low setting
5. Wok setting (wok burner)
6. Roasting setting (wok burner)
Each burner is fully adjustable between high and low settings.
• Press the control knob and turn it anticlockwise. The burner will ignite.
• Keep the control knob fully depressed for at least 3 seconds
• If desired, turn the wok selector ring to the roasting setting (6).
4
• The wok burner will switch automatically to the wok setting if the
It is possible to switch between wok setting and roasting setting and
back during cooking.
between high and low settings. The thermocouple safety pilot has
been activated.
The inner ring (wok setting) will switch off and the outer ring
(roasting setting) will switch on.
control knob of the wok burner is set to 0.
Please note! If the control knob is in the off setting (0-setting) the
selector ring cannot be changed to the roasting setting. Always turn this
knob back completely to 0!
EN 3
OPERATION
Use
error
good
wok ring
Pans
• Always ensure than the flames stay under the pan. A lot of energy
is lost if flames burn around the pan. The handles may also become
too hot.
• Do not use pans with a base diameter smaller than 12 cm. Smaller
pans are not as stable.
Wok ring and small pan grid
The wok ring for use with the wok burner supplied or obtainable as an
accessory provides extra stability for woks with a round base. The small
pan grid supplied or obtainable as an accessory makes it possible to
use very small pans.
Do not use the small pan grid on the wok burner. Do not use the wok
ring on the wok roasting setting. This can result in discolouring.
Pan support
Place the pan supports vertically, without sliding over the drip tray. Use
the leads to position the pan supports on the drip tray.
EN 4
small pan grid