Asko DBI663IS Installation manual
DishwasherINSTALLATION INSTRUCTIONS
Installation instructions
32 3/4 - 34 7/8
22
28 1/8
24*
5 1/8 - 7 3/8
2
4 1/4
47 1/8
28
['']
Nominal dimensions. Actual measurements may vary.
* If European widths of 23 5/8'' (600 mm) is required, remove the trim kit.
REMOVE
Important safety instructions
• Connections to electricity, water, and drainage must be performed
by a qualified professional.
• Always follow applicable regulations for water, drainage, and
electricity.
• Take care during installation! Wear protective gloves! There must
always be two people!
• Place a drip tray on the floor beneath the dishwasher to prevent
damage from any water leaks.
• Before screwing the dishwasher into place, test the dishwasher by
running the Rinse and hold program. Check that the dishwasher
fills with water and drains. Also check that none of the connections
leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the outlet turned off while
installing the dishwasher!
Transport protection for the door
Do not forget to remove the transport protection for the door when
unpacking the dishwasher.
Trim kit
The dishwasher is equipped with a trim kit to fit the 24'' (610 mm) cutout
standard. If a European width of 23 5/8'' (600 mm) is required, remove
the trim kit.
Adjust the trim kit
The trim kit can be adjusted backward to level the dishwasher tub.
2
Placing the dishwasher
24
5 3/8
2
4
24
32 3/4* - 34 3/4
['']
*32 1/4'':
The electrical and
water supplies should
enter through the area
indicated by the
shading on the
illustration.
Remove the trim kit.
3½”
¾”
3½”
Frameless
cabinetry
Filler
Framed
cabinetry
The dishwasher is intended to be built in under a countertop. The
built-in measurements are shown in the illustration. Make sure that the
cord and hose hole's edges are even and will not damage the drain
and inlet hoses or the power cord.
NOTE!
Framed cabinets require additional finished filler material behind the
face frame for a proper installation. A minimum 3½” (89 mm) finished
return is required on all sides of the opening.
Fit the protective film
Fit the protective film (packed in the document bag) to the underside
of the countertop. The protective film is to protect the countertop from
moisture.
NOTE!
The surface to which the protective film is fitted must be clean and
dry.
3
Loading...