Asian Express PL 1690R, PL 1690T User Manual
FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
This product meets the applicable Innovation, Science and Economic Development Canada technical specifications.
Ce produit répond aux spécifications techniques pertinentes d'Innovation, Science et Développement économique applicables.
WARNING!
CHOKING HAZARD
Not suitable for children under 3 years.
Conforms to safety requirements of FCC.
©2017 Rooftop Brands™ All rights reserved
Tel: + (1) 949-566-9573 • www.propelrc.com
11
-
Small parts.
Made in China
V 1.0
TM
TAU
Palm Sized High Performance Drone
INSTRUCTION BOOKLET
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect TAU™ battery from charger immediately after the
TAU™ battery is fully charged. Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
2
4
3
1
3
C
T
H
4CH3CH
TAU ™
2.4G Wireless Controller Instruction BookletSpare PartsUSB Charging Cord
Colors and styles may vary slightly
ARTWORK NO. DESCRIPTION MDSER DESIGNER DAT E
C06-BBB-TAU IM 114.3×174.6mm Tina Johnny 2017/6/29
备注：带气压定高。
TABLE OF CONTENTS
Features
............................................................................................................2
Remote Battery Installation
Charging Your TAU™ Battery
TAU ™ Quadrocopter Diagram
Remote Diagram
Removable Controller Grips
Preparing For Flight
Syncing Your TAU ™
Flying Tips
..........................................................................................................4
Recognizing the Front and Rear of the TAU ™
Automatically Take OFF / LAND
Speed Setting Button
Understanding The Altitude Lock Sensor
T (Training)Mode
3/4 Channel Select
Forward / Backward Trim
Banking Left / Right Trim
4 Channel Flight Control
3 Channel Flight Control
Calibrating The TAU ™
How To Do 360˚ Stunt Rolls
TAU™ Warnings
................................................................................................... 10
Battery Warnings
Care and Maintenance
Replacing The Propeller Blade
FCC Part 15 C Notice
....................................................................................... 2
...................................................................................... 2
. ....................................................................................3
...................................................................................................3
........ ................................................................................3
...............................................................................................
.................................................................................................
...................................................................5
....................................................................................5
.............................................................................................. 5
......................................................................... 5
.................................................................................................. 5
................................................................................................. 6
..........................................................................................6
..........................................................................................6
........................................................................................... 7
...........................................................................................8
..............................................................................................8
........................................................................................9
.................................................................................................10
........................................................................................... 10
...................................................................................10
..............................................................................................11
FEATURES
• Built in 6 axis gyroscopic chip keeps the TAU™ extremely stable in all conditions.
• New T (training ) mode helps beginner pilots learn how to fly.
• Automatically starts and lands with the push of a button.
• Unique switch blade technology allows for 3ch and 4ch flight modes.
• 3 different speed settings for slow to high speed flying.
• Air pressure sensor locks flight altitude.
• LED directional lights makes the TAU™ easy to follow.
• 2.4G radio allows for a 200 foot operational range.
4
4
• The TAU™ is engineered for incredible maneuverability including 360˚ aerial stunts!
REMOTE CONTROL BATTERY INSTALLATION
1. Unscrew the battery cover from the back of the remote control.
2. Install 2 “AAA” alkaline batteries into the battery pack as shown in the diagram.
3. Replace the battery cover and secure it.
Battery Cover
Battery Compartment
(2 “AAA” batteries not included)
CHARGING YOUR TAU™ BATTERY
1. Turn the TAU™ over and carefully remove the battery (see diagram A).
2. Slide the battery into the USB charger and then connect the USB charging cable to the charger
(see diagram C). Connect the universal end of the USB cable to your computer’s USB port (see diagram B).
C AUTION: improper connection may damage the TAU™ battery.
3. Average charging time is about 70-90 minutes.Red LED indicator goes off when battery is fully charged.
A full charge will allow for about 5-6 minutes of flight time depending on environment and user input.
A
B.
C.
-
+
Universal USB Charging Cable
IMPORTANT: ALWAYS REMEMBER TO UNPLUG YOUR CHARGING CORD WHEN NOT IN USE!
Note:
Thank you for purchasing the TAU™ 2.4 G Palm Sized High Performance Drone. Please read this instruction
booklet as it contains valuable information on how to properly fly and care your TAU™ .
1 2
Once connected to computer charger LED will flash if the battery is not inserted.
The LED will stay solid red when charging.
Loading...