Asian Express PL1180-T User Manual
FCC Part 15 B Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
ZIPP NANOCOPTER
2.4Ghz Indoor/Outdoor Quad Rotor Helicopter
INSTRUCTION BOOKLET
WARNING!
CHOKING HAZARD
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, CPSIA and FCC.
©2013 Rooftop Brands™ All rights reserved
Tel: + (1) 949-566-9573 • www.propelrc.com
11
-
Small parts.
Made in China
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect Zipp Nanocopter from charger immediately after the
Zipp Nanocopter is fully charged. Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
2.4G Wireless Controller Instruction BookletSpare PartsZipp Nanocopter
Colors and styles may slightly vary.
TABLE OF CONTENTS
Features
............................................................................................................ 2
Remote Battery Installation
Charging the Zipp Nanocopter Battery
Zipp Nanocopter Battery Installation
Zipp Nanocopter Diagram, Remote Diagram
Preparing For Flight
Syncing Your Zipp Nanocopter
Flying Tips
........................................................................................................ 4
Turn Left / Right Trim
Forward / Backward Trim
Banking Left / Right Trim
Throttle Sensitivity Trim
Speed Select button
Flight Control
360˚ Stunt rolls
Troubleshooting
...................................................................................................... 7
.................................................................................................... 8
.................................................................................................. 9
Battery Warnings, Care and Maintenance
FCC Part 15 B Notice
..................................................................................... 2
.......................................................................... 2
............................................................................. 2
.................................................................... 3
...............................................................................................
.................................................................................
............................................................................................. 5
........................................................................................ 5
........................................................................................ 6
.......................................................................................... 6
............................................................................................. 6
...................................................................... 9
............................................................................................ 11
FEATURES
Built in 6 axis gyroscopic chip keeps the Zipp extremely stable in all conditions.
4 channel flight controls allow for incredible manoeuvrability including 360˚ aerial stunts!
5 speed settings for beginner to advanced Zipp Nanocopter pilots.
LED directional lights makes the Zipp easy to follow.
Replaceable Li-poly battery included.
200 foot range.
4
4
REMOTE CONTROL BATTERY INSTALLATION
1. Slide the battery cover off of the remote control.
2. Install 6 “AA” alkaline batteries into the battery pack and
then install the pack in the controller as shown in the diagram.
3. Replace the battery cover.
CHARGING THE BATTERY
1. Connect the battery to the adaptor as shown (see illustration A).
2. Connect the USB charging cord to your computer’s USB port (see diagram B) .
The charger's charging indicator lights red to show that charging is in progress.
3. Average charging time is
approximately 40-50 minutes. The
Zipp Nanocopter operates for approximately 6-7 minutes on full charge.
4. The charging indicator turns off when the battery is fully charged.
IMPORTANT: ALWAYS REMEMBER TO UNPLUG YOUR CHARGING CORD WHEN NOT
IN USE!
Battery Cover
Battery Compartment
(6 “AA” batteries)
A
B.
ZIPP NANOCOPTER BATTERY INSTALLATION
1. Slide the fully charged battery into Zipp Nano battery compartment (see diagram C).
2. Connect the power cord as shown on diagram D, the copter’s LED lights will light up and
flashing when you connect the power cord correctly.
Caution: The power cord fits only in one way. Do not force it.
Thank you for purchasing the Zipp™ 2.4 G Indoor Zipp Nanocopter. Please read this instruction booklet as
it contains valuable information on how to properly fly and care for your Zipp Nanocopter.
1 2
C D
Loading...