Ashley L000468 Installation Manual
Wire connectors
2pcs
Canopy
Chain Loop
Chain
Chain Loop
Quick Link
Ground Screw
Green Ground Wire
1-4 Screw,
Supplied with
Mounting Hardware pack
Crossbar
Outlet Box
Failure to read and carefully follow all instructions
could result in fire or serious bodily injury or death.
SIGNATURE DESIGN BY ASHLEY™ All Rights Reserved. Feb,2016 Page 1 Of 6
To avoid in shock, fire or serious bodily injury or
death it is very important that the electricity servicing the fixture is turned
off before and during installation.
CAREFULLY READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY. Because this fixture is
connected to live electrical wires, it is strongly recommended to consider
installation by a licensed electrician.
THIS FIXTURE SHOULD TAKE APPROXIMATELY 10 MINUTES TO ASSEMBLE.
MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED.
TOOLS: You will need following tools or equipment:
ladder, screwdriver, adjustable wrench, wire cutters and
pliers.
UNPACK THE FIXTURE: You should have received the
following parts in the package: canopy, chain, quick link,
Fixture Lamp. To protect the finish, place all parts on a
soft surface.
MOUNTING HARDWARE PACKAGE: (2) Expanding nut, (2)
1-4 x 1-1/4" screw, crossbar, green ground screw and (2)
wire connectors.
FIXTURE ASSEMBLY:
Desired length of chain required as to hang the fixture at the
desired height, remove or add chain as desired. Using pliers,
open one end link of chain and attach to screw collar loop,
attach the quick link to end link of the chain and attach the
quick link to chain loop and then secure with small nut.
Thread fixture wire and Supply Ground Wire UP through
every other link of chain.
TO SPREAD A LINK OF CHAIN
Use a pair of pliers and a screwdriver as shown above,
being careful to warp the jaws of the pliers with cloth to
protect the finish of the chain.
ASSEMBLY INSTRUCTION:
READ AND SAVE THE INSTRUCTIONS.
WARNING
WARNING
SIGNATURE DESIGN BY ASHLEY™ All Rights Reserved. Feb,2016 Page 2 Of 6
THIS PRODUCT IS FOR INDOOR USE ONLY! OUTDOOR USE COULD RESULT IN SHOCK, FIRE OR SERIOUS BODILY INJURY
OR DEATH. ALL WIRING MUST BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRIC CODES. IT IS STRONGLY
RECOMMENDED THAT YOU USE A QUALIFIED ELECTRICIAN.
THIS FIXTURE MUST BE MOUNTED TO A UL LISTED OUTLET BOX CAPABLE OF SUPPORTING THE FIXTURE.
FAILURE TO FOLLOW THIS REQUIREMENT COULD RESULT IN THE FIXTURE FALLING CAUSING SERIOUS BODILY INJURY OR
DEATH.
1. Disassemble the cross bar from canopy by removing the two screw provided with the canopy. Drill the expanding nut into
ceiling and attach the cross bar to the ceiling using the two screw provided with the mounting hardware pack.
2. Wrap Supply Ground Wire of lamp assembly and Supply Ground Wire of junction box together around screw of Crossbar.
Tighten the ground screw with a flat head screwdriver.
3. Connect the white or ribbed fixture wire to the white supply wire in the outlet box using the TWIST-ON wire connectors
provided. Connect the black or smooth fixture wire to the black supply wire in the same manner. Install the fixture Supply
Ground Wire under the green group screw on the crossbar wire then connect the fixture Supply Ground Wire to the supply the
Supply Ground Wire in the outlet box using the TWIST-ON sire connector provided.
4. Tuck the wires carefully inside the outlet box. Spread the electrical splices so that the black wires are on one side of the outlet
box and the white wires are on the other side. Next raise the canopy to the ceiling and attach back to cross bar by using two
screw provided with the canopy.
FINAL ASSEMBLY
1. Install a 60 watt max. Medium base type "A" bulb (not included) into each socket.
Installation of a bulb exceeding 60 watts maximum could result in fire, serious bodily injury or death.
2. Restore power after installation is fully complete. Your fixture is ready for use.
ASSEMBLY INSTRUCTION:
READ AND SAVE THE INSTRUCTIONS.
WARNING
To avoid shock, fire or serious bodily injury or death it is very important that the electricity servicing
the fixture is turned off before and during installation.
WARNING
WARNING
Black or Smooth
Fixture Wire
Canopy
Outlet Box
Ground Screw
Green Ground Wire
1-4 Screw,
Supplied with
Mounting Hardware Pack
Crossbar
White or Bibbed
Fixture Wire
Loading...