Ashdown Kylstron Bass Magnifier Operational Manual

OPERATING INSTRUCTIONS
ASHDOWN KLYSTRON BASS MAGNIFIER
OPERATING INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING - When using electrical products, basic precautions should be followed, including the following:
1. Read all the instructions before using the product.
a wet basement or near a swimming pool, or the like.
3. This product may cause permanent hearing loss. Do not operate for long periods of time at high volume level or at any level that is uncomfortable. If you experience any hearing loss or ringing in the ears, you should consult an audiologist.
4. The product should be located so that its location or position does not interfere with its proper ventilation.
5. The product should be located away from heat sources such as radiators, heat registers, or other products that produce heat.
6. The product should be connected to a power supply of the type described in the operating instructions or as marked on the product.
7. The power supply cord of the product should be unplugged from the outlet when left unused for a long period of time.
8. Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.
9. The product should be serviced by qualified personnel when: a.The power supply cord or the plug has been damaged; or b. Objects have fallen, or liquid has been spilled into the product: or c.The product has been exposed to rain or moisture: or d.The product does not appear to operate normally or exhibits a marked change in performance: or e.The product has been dropped, or the enclosure damaged.
10. Do not attempt to service the product.All servicing should be referred to qualified service personnel.
11. For continued protection against the risk of fire, replace fuses only with those of the same type and rating as indicated on the back of the product.
WARNINGS USED ON THE EQUIPMENT
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE KLYSTRON BASS MAGNIFIER DESIGN PHILOSOPHY
This is a NO COMPROMISE design using the best parts available wherever possible. Some examples of this are as follows:-
Gold plated jack sockets for reliability and long life.
Full Metal XLR sockets for strength and their positive latching facility.
All MOSFET output devices for reliability and superior bass power.
Doubling up of the reservoir capacitors for the output stage providing double the available
‘Punch’ or instantaneous transient power ( very important for bass ).
Doubling up of the cooling fans for reliability and reduced fan noise ( 2 fans can run at half
the speed to provide the same cooling capacity and as a consequence generate only half the noise of one fan running at twice the speed).
Speed controlled fan drive circuit. Again this reduces the amount of fan noise as the fans run
slow when the unit is cool and increase in speed with output power demands.
Powerful TOROIDAL mains transformer.This is more expensive than a laminated stack
transformer but has better regulation i.e. provides more power on demand without sagging out and also has a minimal external magnetic field which means that single coil pick up basses are less likely to pick up mains hum from the amplifier.
FET input circuit to the preamp for ‘Warmth’ even when using the CLEAN input mix setting.
D.C. heaters for the TUBE section for low noise operation.
Switch on delay for silent power up.
Thermal trip for output protection.
Relay switched speaker output lines for silent power down.
Sub Bass output and Sub Harmonics facility for really serious bottom end.
Plywood Cabinets and Head Sleeves, screwed (not pinned).
Metal Corners and bar handles.
Acoustically transparent Custom Grill Cloth.
Air Sealed speaker cabinet back plates.
16swg (1.5mm) zinc coated heavy duty metalwork.
Everything possible has been done to make this a reliable, top of the range, minimum service, high quality, long lasting powerful bass amplifier.
We know you will appreciate the effort that has been put into the design and manufacture of this unit and you will be rewarded in your choice of bass amplifier by long life and reliability.
Loading...
+ 5 hidden pages