Asc SP003 User Manual

SP003 Solar Water Pump Kit Instructions

By All Solar Central

www.allsolarcentral.com

Thank you from the entire ASC family for purchasing
an ASC solar product! Please read this entire booklet
before assembly.

Package contents:

1 x Water Pump with 16 ft. Cable
1 x Solar Panel
1 x Solar Panel with Bracket
2 x Extension Tube
1 x Ground Spike
1 x Floating Foam
1 x Set of Fountain Nozzles

Notes: If there is any damage to the product or missing
parts, please contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus

Assembly Steps:

1. Connect the bracket, tubes and spike together.
Then attach the solar panel to the bracket. Slide
the holding bracket into the inside lip of the top
half of the solar panel frame. The bracket holds
the weight of the solar panel. The solar panel can
be adjusted for optimal sunlight by using the
wingnut. Please see the diagram.

2. Insert the spike into the ground. Position the
solar panel so it’s facing south (in northern
hemisphere) as much as possible to maximize
daylight hours. It is important to angle the solar
panel to face the sun when the sun is at its

highest point. Ensure the solar panel is not
shaded by trees, shrubs or buildings.

3. Connect the Pump to the back side of the Solar
Panel. IMPORTANT!! Slightly twist the connectors
when connecting to make sure the rubber seals
are fully in the grooves.

4. SOLAR PUMP FUNCTIONS

This pump runs from direct sunlight. The pumps
performance is directly related to the amount
and strength of sunlight received by the solar
panel. This solar pump is designed primarily to
operate in summer months but can also work in
spring and autumn if there is direct sunlight.
Notes: This model DOES NOT come with a
battery, so the pump will only work when the
solar panel is in sunlight

.

1

5. PUMP MAINTENANCE

•

If you find the pump starts losing power or stops
working, please clean the pump filter and
impeller with clean water.

6. TROUBLE SHOOTING

• Check to see if the solar panel, pump and
led light are connected properly

• Check to see if the solar panel is correctly
positioned facing the sun. Please ensure
the solar panel is not in the shade or
obstructed by trees, shrubs or a building
(see step 2).

• Check water level and make sure the
pump is fully submerged in water

• Check to see if the pump filter/impeller is
blocked by debris

• Check to see if the fountain tubing is
blocked by kinks or obstructions

• Check the pump. It may be “air locked”.
Turn the pump on/off switch several
times to clear any air that may have been
trapped.

7. TECHANICAL DATA

Max. Pump Water Flow: 180LPH

• Max. Pump Water Lift: 50CM / 20IN

• Working Voltage: DC6V – DC8V

• Pump Working Power: 0.65W – 1.15W

• Protection Grade of Pump: IP68

• Solar Panel: 2.5W; 8V; 0.312A

• Solar Panel Size: 190x150x18MM

• Protection Grade of Panel: IP44

8. WINTER PROTECTION

Indoor storage is recommended during winter
months. Normal operating temperature is
between 50 and 113 °F.

Please visit www.allsolarcentral.com for more
products and offers.

2