Asc SF017 User Manual

SF017 Solar Pedestal & Ball Instructions

By All Solar Central

www.allsolarcentral.com

Thank you from the entire ASC family for purchasing
an ASC solar product! Please read this entire booklet
before assembly.

Package contents:

1 x Ball
1 x Pedestal With Rubber Bung
1 x Water Pump
1 x Solar Panel
1 x Solar Panel Bracket
1 x Extension Tube
1 x Ground Spike

Notes: If there is any damage to the product or missing
parts, please contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus

2. Fill reservoir with appropriate amount of water to
fully submerse the pump.

3. Attach the pump to the Rubber Hose.

Assembly Steps:

1. Feed the pump cable and LED Light cable through
the tube in the Rattan Pillar Reservoir and exit
from the bottom of the Fountain Body. Then, use
the provided Rubber Bung to seal the tube hole
to avoid water leaking.

4. Place the Ball and the Pump onto the Pedestal.

1

5. Connect the bracket, tubes and spike together.
Then attach the solar panel to the bracket. Slide
the holding bracket into the inside lip of the top
half of the solar panel frame. The bracket holds
the weight of the solar panel. The solar panel can
be adjusted for optimal sunlight by using the
wingnut. Please see the diagram.

7. Connect the Pump to the back side of the Solar
Panel. IMPORTANT!! Slightly twist the connectors
when connecting to make sure the rubber seals
are fully in the grooves.

Notes: Your Solar Pump Kit might vary. Please
refer to the Solar Water Pump Kit Instructions for
more information.

8. Now your new fountain is assembled and ready
to use.

6. Insert the spike into the ground. Position the
solar panel so it’s facing south (in northern
hemisphere) as much as possible to maximize
daylight hours. It is important to angle the solar
panel to face the sun when the sun is at its
highest point. Ensure the solar panel is not
shaded by trees, shrubs or buildings.

Please visit www.allsolarcentral.com for more
products and offers.

2