ASAP Technology LACA063 User Manual

wireless charger

VER:A

Product Introduction

The wireless charger is an intelligent product, with simple
design and compatible with any mobile phones with Qi
standard. Mobile phone is without plug when charging,
which is more convenient and efficient. It can bring you
with limitless life experience as well as safe and free
experience with wireless charging function.

Product

Outline

Instructions

Insert one end of USB charging cable into power adaptor

1.

or computer. shown as below.

Input Port of Power Supply

LED

This wireless charger could provide power supply for
devices with built-in wireless charging receiver (such
as iphone 8, iphone plus, iphone X, Samsung Galaxy
S8, ect)

Standard Accessories

Wireless Charger
3ft(91.4cm) USB Cable
User Manual

Product Specification

Input: 5V/2A

Output: 5W
Charging Distance: ≤8 mm
Charging Efficiency: ≥73%
Size: D89X7.4mm

Attention:

1. Please keep the charger away from water or

other liquid.

2. If you need to clean the charger, please make
sure it is not connected power supply.

3. Using Environment temperature remains 0 -45

Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,

2. Insert another end of USB charging cable
into Micro USB port of the wireless charger.
The LED indicator lights up to indicate well
connectivity.

3. Place your phone on the wireless
charger.Make sure that the phone
is well located at the charging area
of wireless charger.When the phone
is being charged, the LED indicator
will light up automatically to show
charging status.

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does
cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna

-- Increase the separation between the equipment and
receiver.

-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV

technician for help.

Note: The manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications
to this equipment. such modifications could void the
user’s authority to operate this equipment. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.The distance
between user and products should be no less than 20cm