Asante Technologies IC35160G, IC35160T User Manual

IntraCore® 35160 Series
A Communication Division of UIC Corporation
IC35160G
The IntraCore® 35160 Series is Asanté’s most powerful, flexible family of Layer 2 backbone, core and distribution level aggregation switches. Tailor this IntraCore® switch with hardware and software to precisely match your network needs—today and in the future.
High Port Count Single Chip Gigabit Solution for Layer 2 switching.
16-port Gigabit Managed Switches
Layer 2
IC35160T
Choose from two design versions:
12 ports 10/100/1000BaseT with 4 ports auto-selectable
GBIC/1000BaseT Copper
12 ports GBIC for Fiber backbones with 4 ports auto-
selectable GBIC/1000BaseT Copper
Deploy QOS schedules and priorities (voice, video, audio, image) throughout
your network with Multicasting technologies: IP multicast with IGMP, manual population of multicast tables, IEEE 802.1p queues to support VOIP, Video and ERP type applications.
Multiple Management Options: SNMP, Web, Telnet, RMON, console Software Redundancy: Two banks for storing rmware Jumbo Packet: Will support frames up to 16384 bytes with user congurability Security: Port based, Station detection, Duplicate IP address VLAN: 1024 VLANs supported with IEEE802.1Q tagging Emergency backup, Emergency Power Supply provides optional redundant
power.
Introduction
The IntraCore® 35160 Layer 2 family of Gigabit Ethernet switches is Asante’s most powerful, flexible range of backbone and aggregation switches.
With 16 ports of Gigabit Ethernet offered in two design options, your cost of ownership is reduced considerably over other vendors switches by using mix and match GBIC/Copper ports.
By using a single-chip state-of-the-art architecture with shared memory, wire speed switching at Layer 2 is achieved on all ports.
Quality of Service In the simplest sense, Quality of Service (QoS) means providing consistent, predictable data delivery
service. In other words, satisfying customer application throughput requirements including timing, bandwidth and service prioritization.
QoS is to the ability of a network element (e.g. an application, host or router) to have some level of assurance that its traffic and service requirements can be satisfied. To enable QoS requires the cooperation of all network layers from top-to-bottom, as well as every network element from end-to­end. Any QoS assurances are only as good as the weakest link in the "chain" between sender and receiver.
For network’s that require more than just performance switching, the IntraCore® 35160 has a comprehensive array of multicasting and Quality of Service tools to provide tailored service levels in operations that involve Voice, Video, Image and Data traffic.
With future upgrade options that include Classification and filtering based on Layer 2 packets, Layer 3 protocols and Layer 4 protocols (TCP, UDP) and remapping priorities using DiffServ Code Point (DSCP), traffic flows can be identified and managed by MAC address, VLAN, Port, source and destination address.
Jumbo Packet Support Jumbo Packet transmission is a requirement seen largely in Higher Education, Research and Distributed
Scientific computing environments, this commonly involves high level traffic flows of web, video and database transaction processing between host and client.
Our implementation of Jumbo Packet support allows users to manually configure oversize frames of up to 16384 bytes to be transmitted. Asanté’s end-to-end Jumbo Packet support includes FriendlyNET® GigaNIX network cards also.
Low Cost Failure Backup Power Option New to Asanté is the provision of an optional DC backup power supply to ensure continued operation in
situations of primary power failure. Used with Uninterrupted Power Supplies, Asanté IC 35160 can ensure high productivity and extremely low downtime on mission critical networks.
The IC35-EPS12 operates at 12VDC and is used in standby mode simultaneously on-line with the 90­260VAC primary power system. Should the primary power fail, the IC35-EPS12 automatically goes liv e
asante.com/intracore 35160 Feb 2003 2
and both LED indication on the switch hardware and SNMP alarms will be enabled.
Market Applications This family of switches is ideally positioned for those organizations and businesses that operate web
based, multimedia and high performance networks including, MTU, Higher Education, Scientific Research, E-Business Enterprise applications (SAP, ERP, CRM, and SCM) in Manufacturing, Retail, and Public Services including Government and Healthcare where control of latency and jitter along with traffic management by user and service type is critical.
Use the IC35160 for aggregating multiple workgroups of 10/100 24/48 port switches (IC3524/48), connecting multiple Gigabit Fiber or copper backbones in the network core or even distributing bandwidth within the data center to servers.
FEATURES
Single-Chip Layer 2 Switch: Forwarding rate of 24 million packets per second at full wire speed over all network interfaces in a unit
32 Gbps switch fabric (per unit) minimizes blocking and latency Runs cooler and more reliably than older, multi-chip designs
Extensible Platform: Choose from 2 popular Gigabit configurations with auto-selectable switching
- 12 ports 10/100/1000BaseT and 4 dual function ports of GBIC/1000BaseT
- 12 ports GBIC and 4 dual function ports of GBIC/1000BaseT Run multi-mode or singlemode fiber 1000 Mbps (1000BaseSX/LX/LH/LZ) using GBIC transceivers
Run standard Category 5E UTP copper cables up to 100 meters at 1000 Mbps (1000BaseT) Class of Service/Qos Multiple priority queues ensure mission critical applications get the bandwidth and priority they need. IEEE802.1p: 8
queues per port.
Chargeable, upgrade firmware available in first half 2003 will enable Packet classification and filtering based on Layer
2 packets, Layer 3 protocols and Layer 4 traffic types TCP and UDP also remapping of traffic flows using DiffServ and based on MAC address, VLAN, L2-4.
Multicasting support: Internet group management protocol (IGMP) optimizes multicast bandwidth by allowing multicast traffic only to
registered users; minimizes denial of service attacks from unknown sources. 256 multicast groups are supported. Manual population of the multicast table is available, static entries in the multicast table are saved to FLASH.
Virtual LANs: Logically organize nodes into 1024 port based VLANs compliant with IEEE 802.1Q with VLAN Tagging Overlapping VLANs are ideal for sharing and segmenting traffic and security.
Addresses Supports 2000 MAC addresses with MAC address ageing management and MAC/IP address table display Port Mirroring On ingress only in first release firmware. Port Security Station move detection and Duplicate IP address detection with ONE trusted addresses per port.
Spanning Tree IEEE 802.1D supported Jumbo Packets Supports frames, user configurable up to 16384 bytes Flow Control IEEE 802.3x supported
Management
Graphical User Interface: WEB type HTML browser-based with password protection for local and remote management Console Interface: Menu-driven telnet or out-of-band via front panel console port Command Line: Version 2 firmware introduces CLI support for all features SNMP: SNMP v1 supported with MIB II, RMON, 802.1Q, 802.1p, Bridge MIB and Asante private MIB
asante.com/intracore 35160 Feb 2003 3
RMON: 4 Groups (Stats, History, Alarms, Events) Front Panel: Graphical representation of unit with real-time network status General Information: Software version, dual firmware banks; admin, system and bootstrap info; switch address and uptime system clock Statistics: User-configurable graph types (bar chart, line chart, table); counters (since up, rate, since reset) for RX/TX/Error for
each port and unit. Table view also shows current, peak average and total packets for each port Port Configuration: State (forwarding, blocking), status (enabled, disabled), link status (up, down) and mode (speed, duplex); auto
negotiation, flow control, priority and security. Detailed statistics include TX counters (total frames, total bytes,
dropped frames), RX counters (total frames, total bytes, unicast, non-unicast), frame counters (multicast, broadcast,
by packet sizes), collisions and errors (undersized, oversized, CRC/alignment, fragments, FCS, late events, total) Firmware Configuration Configuration files uploading/downloading
Image files downloading for updating firmware, TFTP
SPECIFICATIONS
Connectors: Gigabit Ethernet with Auto-Uplink™ (10/100/1000BaseTX): RJ-45 or GBIC holder for GBIC transceiver module
Console: Serial (RS-232): DB9 Status Indicators: Separate link-activity, speed (10/100/Gigabit) and duplex (full or half) LEDs for each port; system power, emergency
backup power.
Physical Characteristics IntraCore® 35160-T: 17.5 x 10.0 x 1.8 inches (444 x 254 x 46 mm), 8.0 lbs (3.6 Kg) IntraCore® 35160-G 17.5 x 14.0 x 2.7 inches (444 x 355.6 x 68.58 mm), 9.0 lbs (4.1 Kg) Mounting: Install into a standard 19-inch rack (1 RU height) or placed on a desktop; rackmount kit and rubber feet included
Environmental Range Operating Temperature: 32º to 104º F (0º to 40º C) Relative Humidity: 10% to 90% non-condensing Power: Auto-switching, 90/260 VAC, 50/60 Hz; grounded IEC cord Redundant DC Power: 12 VDC Auto switching from main 110/260 VAC for emergency backup
Standards Compliance IEEEE: IEEE 802.1D spanning tree and bridge filters IEEE 802.1p prioritization (class of service) IEEE 802.1Q virtual LAN (VLAN) IEEE 802.3x full duplex and flow control IEEE 802.3z 1000BaseSX over 50 micron multi-mode fiber; maximum distance 1,804 feet (550 meters) IEEE 802.3ab 1000BaseT over Category 5 UTP (4 pairs); maximum distance 328 feet (100 meters) IEEE 802.3u 100BaseTX over Category 5 UTP (2 pairs); maximum distance 328 feet (100 meters) IEEE 802.3 10BaseT over Category 3 UTP (2 pairs); maximum distance 328 feet (100 meters)
IETF: RFC 1155 SMI RFC 1757 RMON RFC 1157 SNMP RFC 1493 Bridge MIB RFC 1213 MIB II Asanté Private MIB
Safety: UL 1950, CUL, TUV/GS, Emissions: FCC Class A, CE
Technical Support and Warranty
IntraCare™:
AsanteCare: Optional extended technical support and product warranty for additional years.
IntraCare: Free technical support and advanced warranty support for 3 years. Includes free telephone support, 24-hour support via web and ftp, complete product warranty with 2nd business day (within US) advanced replacement and software maintenance agreement.
asante.com/intracore 35160 Feb 2003 4
ORDERING
INFORMATION
IntraCore® 35160-T 12-port 10/100/1000, and 4 dual function ports GBIC/1000BaseT copper. Layer 2 99-00747-01
Accessories
**T0001 CIBG
*rebmuN traP étnasA noitpircseD ledoM
10-77700-99 61553/06153/8453CI rof CDV 21 ,ylppuS rewoP tnadnudeR ycnegremE 21SPE-53CI
10-94500-99 srotcennoc CS edomitlum CIBG XSesaB0001 **XS0001 CIBG 10-05500-99 mk01 edomelgnis/mk1 edomitlum CIBG XLesaB0001 **XL0001 CIBG 10-37600-99 sertem 001 latem CIBG TesaB0001
70-74600-99 sertem 001 citsalp CIBG PTesaB0001 **PT0001 CIBG
For international part numbers, please refer to sales. **See GBIC datasheet and Asanté price list for additional GBIC’s and GBIC price bundles.
47709 Fremont Blvd, Fremont, CA 94538 USA · Phone 408.435.8388 · Website www.asante.com
© 2008Asante - a Division of UIC Corporation. Allrights reserved. Asante and FriendlyNET are trademarks of UICUSA.
All other namesmay be trademarks or registered trademarksof their respective owners. Specifications subject
A Communication Division of UIC Corporation
to change withoutprior notice.
IC35160-T (99-00747)
asante.com/products/switches 5
050708 IC39480 DS
Loading...