ASA Electronics OEC1550 User Manual

OEC1550 Troubleshooting Guide

Radio will not turn ON

• Try the reset button on the radio.

• Check fuse on the radio.

• Confirm 12V+ on battery wire to radio (YELLOW wire).

• Confirm 12V+ on accessory wire to radio (RED wire).

• Confirm Ground.

Radio turns ON, but no sound

• Verify Volume¸ Fader/Balance¸ Mute controls are set correctly (see owners

manual).

• Try RESET button.

• Verify proper speaker connections.

• Check for shorts or opens on speaker wires.

CD does not load fully

• Make sure unit has power and no other CD is currently inside.

• Inspect radio’s chassis to verify shipping screw(s) have been removed.

CD does not play correctly

• Check to make sure disc is inserted correctly.

• Verify disc is free from dirt, scratches, etc.

• Check with factory CDs.

• Check factory original CDs for compatibility warnings (due to various copy-

protection, multi-media content, etc).

• Disc skips during playback – verify you have not exceeded 30 degrees mounting
angle.

No AM or FM reception

• Verify you are tuned to a valid station.

• Check your antenna connection on rear of stereo.

• Try a different antenna.

No TV antenna reception

•

Verify solid antenna connections on both sides of cable jack on entertainment
center and also to aerial.

• Verify crimped cable plug connection, check for shorts or exposed wires.

• Verify that the TV is setup property for Air/Cable TV settings.

No Power to 12 volt DC outlet

• Verify solid 12 volt connection to rear of adapter.

• Inspect for any debris inside adapter.

No Phone jack operation

•

Verify solid connections at and from rear of entertainment center to phone source.

• Inspect for any debris inside adapter.

• Verify that the coach is connected to a land line phone connection.

No Power to 110 AC outlet

•

Verify connection from rear of entertainment center to 110 AC source.

•

Verify circuit is not tripped or fuse blown.

No audio from speaker jacks

•

Verify both jacks are operable.

•

Verify connection to radio source from speaker jacks.

•

Try using a different speaker wire connector plug.

•

Verify proper radio settings to speaker jacks.

B. Woods
Technical Services
May 01, 2007