1 2 3 4 5 6
6343 - 6343 I - 6343 s
No rinse agent / No salt / Water cut off indicator
Programme lights
Half Load indicators
Perfect Rinse İndicators
Delayed Start indicator
Programme follow-up indicators
Start/Pause/Cancel button
Delayed Start button
Function keys
On/Off button
To turn the machine on, press and hold down the On/Off button for 1
second. Indicator lights on the panel will illuminate. To turn the machine
off, press and hold down the On/Off button for 1 second. In Off
position, indicator lights will turn off.
Programme Selection button
Refer to "Table of Programme Data and Average Consumption Values"
to select a programme suitable for your dishes. Press the Programme
Selection key repeatedly until the light of the programme you want to
select is illuminated.
Start/Pause/Cancel button
It is used to start, pause or cancel a selected programme or function.
When you press the Start / Pause / Cancel key, the washing
programme you have selected will start.
When your machine is in "Pause" mode, one of the programme follow
up buttons will flash.
A To press the Start / Pause / Cancel key, wait for two
seconds after you turn on your machine by pressing the
On / Off key.
Canceling a programme
Press Start / Pause / Cancel key for 3 seconds to cancel the
programme. Stop pressing when Washing and Drying lights flash
at the same time. Water in the machine will be discharged in 45
seconds. When the End light comes on, the programme will have been
cancelled. Then, you can select and operate a new programme.
A There might be residues of detergent or rinse aid left in
the machine and / or on the pieces washed depending
on the step the programme you have cancelled was in.
Water Cut Off Indicator
If the machine cannot take in water, then the Water Cut Off Indicator will light
on the screen. Once the water flows in, the warning indicator will automatically
switch off.
A When the Water Cut Off indicator lights, make sure that the
water is not cut-off and that the tap is off. Call Authorised
Service Agent if water is not cut-off and the tap is open.
1112
78910
Perfect Rinse Function
Half Load button
Programme Selection button
On/Off button
button
Perfect Rinse Function
Depending on the type of the detergent used, if a detergent dissolving
issue is encountered it will remove the resulting stains from the dishes
and enables the optimum rinsing performance.
Delayed Start
You can delay the startup of the programme up to 9 hours with
Delayed Start button. Press Start/Pause/Cancel key after setting the
Delayed Start. Once the delay time is over, the selected programme
will start automatically.
Every time you press the delayed start button, the 3-6-9 hour lights
will start flashing respectively. If you press on the Start/Delay/Cancel
button while the selected delayed start button is flashing, the delayed
start light will stay on and the countdown will start. When the delay
period is completed, the delayed start light will go off and the selected
washing programme will begin.
A While the 9 hour delayed start lamp is flashing, if you press the
Delayed Start button, the delayed start lights will go off. If you press the
Start/Delay/Cancel button while the Delayed Start Lights are off, the
programme you have selected will start without any delay period.
AYou can follow the amount of delay time left from the delayed start
lights. For Example: Once you have chosen the 9-hour delay period,
when 6 hours is left for the washing programme to start, the 6-hour light
will come on and when there is 3 hours left, the 3-hour light will come
on.
Changing the Delayed Start Time
Press the Start/Pause/Cancel button. The delay time light will start
flashing. You can select the new delay period by pressing the Delayed
Start button again. Save this by pressing Start/Pause/Cancel key
again.
To cancel the Delayed Start;
Press and hold Start / Pause / Cancel key for 3 seconds. The selected
delay time will have been cancelled. Once the cancelation has started,
the water left in the machine will be discharged in 30 seconds.
Half Load button
If you want to run your machine without loading it completely, place
your dishes into the machine as you desire. First press the On/Off
button. After you have chosen the programme of your choice, press the
Half Load button and see that the Half Load light on the panel is on.
Start the programme by pressing the Start/Pause/Cancel button and
you can save water and power. You can use every part of the upper
and lower baskets by choosing Half Load.
Starting your machine
1234
Eco
(Eko *)
Intensive
(Yoğun)
Express
(Hzl 58')
Mini
(Mini 30')
50 ºC 70 ºC 70 ºC 35 ºC
Most economical washing programme for
the medium soiled daily dishes that are
kept waiting.
Suitable for heavily soiled dishes, pots
and pans.
Daily washing programme at which the
medium soiled dishes that are kept
waiting are cleaned in the fastest way.
Suitable for lightly soiled daily dishes that
are scraped or pre-cleaned.
Medium High Medium Low
A+B A+B A+B A
++ - -
++++
+++ -
190 124 58 30
12 17,6 11,8 11,8
1,02 1,70 1,20 0,79
Programme Table
The consumption values shown in the table were determined under standard conditions. Differences may therefore occur under practical conditions. * Reference
programme for testing institutes. The tests in accordance with EN 50242 must be carried out with a full water softener salt dispenser and a full rinse aid reservoir,
and using the test programme.
Programme number
Programme name
Cleaning temperature
Degree of Soiling
Detergents
A=25 cm³/15 cm³ B=5 cm³
Energy (kWh)
Prewash
Wash
Dry
Duration (min)
Water (I)
6343 - 6343 I - 6343 s
1. Open the tap.
2. Plug in to the socket.
3. Open the door of the dishwasher.
4. Place the dishes in accordance with the instructions in the user
manual.
5. Make sure that the upper and lower impellers rotate freely.
6. Put sufficient amount of detergent in the detergent dispenser and
close its lid.
7. Make sure that the lights on programme display are illuminated by
pressing On / Off key.
8. Check if the Salt and Rinse Aid indicators light and add salt and /
or rinse aid if needed.
A Since different salt brands in the market have different
particle sizes and the water hardness may vary,
dissolution of the salt in water may take a couple of
hours. Therefore, the No Salt warning light will remain
on for a while after adding salt into the machine.
9. Select the most suitable programme by using the "Table of
Programme Data and Consumption Values".
10. Select the desired programme you want to run with the Programme
Selection button.
11. Press Start / Pause / Cancel key to start the programme.
A Pay attention not to open the door of the machine
while it is running. If you need to open the door, safety
system will stop your machine. There may be a rush of
vapour when you open the door of your machine; be
careful. The programme will resume running when you
close the door.
A If the Drying lamp is on, the machine will be drying
silently for 35-45 minutes. After a while, the Drying
lamp will switch off and the End lamp will come on.
A Make sure you wait for the drying to finish before
switching off your machine. After the End light has
come on, switch the machine off by pressing the On/Off
button.
12. Press the On/Off key to switch off the machine.
13. Close the tap.
14. Unplug the machine from the socket.
15. Leave your dishes in the machine for about 15 minutes after they
are washed in order to have them cooled down. Your dishes will
dry in a shorter time if you leave the door of your machine ajar
during this period. This will increase the drying effectiveness of your
machine.
18 9901 3537-AA-EN
Loading...